Switching

Hello all, Normally you can run the #show privilege command where you can check the privilege level that you are connected. #show privilegeCurrent privilege level is 2 Is there a way to check the privilege level for others, connected through Telnet...

I currently have a Core stack of 2 Catalyst 3750X.  I purchased 2 Nexus 5548UP to hang off the Ten Gigabit modules of the 3750 stack.  I am having trouble getting the VLANs on the 3750 to trunk over to the 5Ks.  I have configured the up links on the ...

I recently replaced a Catalyst 3560G for a 3650 (my plan is move some AP's from a 2504 WLC to this and configure mobility, however for the moment it is a straight swap).  I more or less just copied the configuration over after a few tweaks with port ...

I have Cisco AP 2702E and when I run dir command I get output below: ap#dirDirectory of flash:/ap3g2-rcvk9w8-mx/ 39 -rwx 215867   Jan 1 1970 00:16:08 +00:00 ap3g2-rcvk9w8-mx 40 -rwx 73           Jan 1 1970 00:16:08 +00:00 ap3g2-rcvk9w8-tx 41 -rwx 593...

Hello Experts, I have found some multiple errdisable commands in my switch. I have no idea why these commands have been defined in my switch. The Network guy before me might have defined these commands. My question is why he has put such a multiple ...

Hi, I have two Cat4500 (as standalone each, not VSS) configured as gateway of my network using HRSP. They are default gateways of many vlans of my network. Regarding STP they use the classic STP 802.1D and one of them are root bridge by lower priori...

I am getting quotes for Structured Cabling and one guy is saying that I can use 40G MPO from my distribution switch up to a 40G MPO patch panel connection and across a 40G MPO trunk but then break it out to 4 x 10G LC ports which I agree with but the...

Does anyone know when Cisco might ship their implementation of 40G-LM4 (aka 40G-Universal)?  This is a transceiver which can employ either two-strand multi-mode (OM3/4) or two-strand single-mode, typically with short distances over single-mode (500m ...

Dear All, We have a cisco ws-c2960s-48fps-l, the problem is from port number 25- 32 are not working.. we tried shut no shut.. nothing no response from port. is it hardware issue? if yes what should be done? if not hardware isssue? what could be t...

We have several Cisco 3750 switches running Version 12.2(25) in our environment.  I have experienced on occasion when I initiate  the sh int status command on a switch stack containing five 3750 switches, it displays a few pages and then the entire s...

Hi I think there are some summary talking about the difference of commands between Nexus7000 and other normal router or Catalyst such as 6500 etc. Anyone knows that and would like to share the link? Thank you

Hi We've bought several SG300 52 port switches, they function well but make a lot of fan noise.  Is there anyway to reduce/control the fan speed so the noise level will decrease?  Several sites suggest to replace the original fans.... but I'm not ver...