Switching

This is an odd case that I have seen before, but not recalling the fix. We have GRE tunnel that runs across an AT&T MPLS cloud. RIP routing works across the tunnel and we can ping the far end of the tunnel. However, we cannot ping or access IPs in th...

HiIam trying to update my WS-C2960-24TC-S IOS from version c2960-lanlitek9-mz.122-55.SE5.bin to higher version but new IOS is not able to boot .any body have a solution for that.Thank you

Hi,So I'm currently running on 15.0.2 SE2 with two WCCP redirects.  I found out that there is a bug that states:CSCuj80767When multiple Web Cache Communication Protocol (WCCP) services are configured on the same interface, all the traffic is not redi...

Hi,I trying to set up inter VLAN on the Cisco 2651XM router. I try to type the IP address on the sub interface but it gives me an error. I need to set up firstthe encapsulation dot1 q. I type encapsulation command but it doesn't recognized.This is th...

Hi,  Just looking for confirmation that with this hardware/software combination, dual homing FEXs is still not supported?    Is this on the roadmap?

I have 1 cisco router 3945, i configure 2 gigabit if 0/1 and 0/2, below the if 0/2 i have many sub-if (vlans), linked to a same number of route maps and acl's to make the router send the packet to a specific destination for each one; today a activate...

Que tal Estimados. Por este medio, solicitaría de su apoyo para su valioso opinión...sobre una duda que surge al día de hoy. Al tener montado un switch catalyst 6506 en un Rack y este rack se quiere mover unos cuantos centímetros; se puede mover dich...

I am setting up the ios archive feature using scp on an isr router.  I am wanting to set this up to archive to an scp server that is remote to the isr but over an ipsec site vpn.  When attempting this, the archive copy commenced but will not complete...

Hi All, Taking the cisco example below, which demos how to PBR. access-list 1 permit 209.165.200.225access-list 2 permit 209.165.200.226!interface ethernet 1 ip policy route-map Texas!route-map Texas permit 10 match ip address 1 set ip precedence pri...

I have a 2960X-24TS-L running "System image file is "flash:/c2960x-universalk9-mz.150-2.EX5/c2960x-universalk9-mz.150-2.EX5.bin"I can SSH or Telnet to VTY ports I can't use the FastEthernet 0 for Management with either Telnet or SSH or to TFTP config...

I have recently heard that when using a 4 port switch module on a router that you need to connect one of the ports directly to one of the router ports in order to bypass the backplane as there is a known issue of packets being dropped when you use th...