Switching

Dears,I am seeing High Cpu Utilization on Layer 3 SwitchL3#sh proc cpu |  ex 0.0                                                                                            CPU utilization for five seconds: 66%/29%; one minute: 68%; five minutes: 68% ...

HI,I HAVE 4506E SWITCH CONNECTED TO 2960 EDGE SWITCHGIG2/6 OF 4506E CONNECT ON PORT GIG0/1 OF 2960I WANT TO LIMIT BANDWIDTH TO 5 MBPS FOR USERS CONNECTED TO 2960TOTAL BANDWIDTH FLOWING FROM 4506E IS 10 MBHOW CAN DO ITPLS HELP ON THIS

DearsI have 3850 switch with integrated WLC and i wonder if i can access the WLC via GUI ,also i need to know if it support Dynamic vlan assignment over SSID thanks

I have an issue in ma nexus 5k. the issue I have attached as screen shot also attached the full running conf of both 5k-1 and 5k-2. Also the connectivity map.Please provide me the command to make STP port type same(network or normal) on both side. An...

Hi allI did a quick search and noticed that there is no previous experience of VLAN discard frames.So I would hope to find some clue here.Currently, my network is experiencing high VLAN discard frames.The statistics can be seen by inputting "show con...

Anyone got this working?I installed the drivers okay using the setup program but after restarting device manager keeps switching the device between other devices and a Com port with a contually incrementing port number so I it's not usable at all.

Hello,In order to enable dual-active detection on 4500 VSS, a port-channel has to be configured as Pagp with dual-active detection. My question is: Does all port-channels connecting to access switches need this enabled or is a single port-channel suf...

Hi All,I am trying to Disable Telnet and enable SSH in Cat Os for 6500 . Can some one help with a step by step instruction ? I have been searching for a while but did not get a convincing answer yet. Please help.Thanks,

Hi guys,I want to test my internet link whic is of 4mbps. I want to understand how do we test this link on router, other than ping test wht could be done to check the thghput of. LinkSent from Cisco Technical Support iPhone App