Switching

Hi all, can anyone tell me what the conduit command does on a pix firewall ?

Hello guru's!The 2940 datasheet tells me that 128 .1q vlan's are supported. But, in real live we see that only 16 vlan's are accepted.Anyone?

Hi,We are going to implement 10 sites with 10 3560 L3 switches. Ijust want to ask is that all the switches have Standard Image and I am going to use RIP V2 for routing. Will I face any issues? Thanks for all the help.RegardsSarfaraz

We have a customer who is deploying an Ericsson IPT solution. The Core Cat6509 switch has a Sup720. At this time we have the ip phones in a vlan & the IPT switch in another vlan & just mrouting between 2 vlans on the Cat6509. The phones are having a ...

Hi all, on an access list , what woulf wildcard 0.0.0.15 mean ?

Dear,ALLWhen i enter L3 of 6509,I always got the Router(boo)>There is a file for bootldrThanks a lotJason

Dear all,As title, which command can help me?Thx.

I have two Cisco 3560's that will each have be on its own VLAN. However I would like each 3560 to have each other's VLAN as well. How do I assign the IP address/VLAN of the "other" 3560 to each 3560. Can I just create a VLAN use the command "ip addr...

I am trying to understand the 'ip pim' commands better. The way I am understanding it currently is in order to run 'pim', 'ip multicast-routing' must be enabled. Once that is enabled, you set an interface in 'sparse-mode' and designate a default RP...

cat4506 connect to cat3750 but it doesnt work.i tried both str8 n cross cable but it doesnt work.cat 4506 configBuilding configuration...Current configuration : 2356 bytes!version 12.2no service padservice timestamps debug uptimeservice timestamps lo...

I have a Cisco 2811 that has 2 Fast Ethernet interfaces. One interface I want to use to control "Routes" on my local private network (Basically just routing back throught same same interface). The other Interface is the LAN side my T1 connection comi...

I set up a SPAN/monitor source and destination port. I have a server attached to the source port, and a sniffer attached to the destination port.When I run my sniffer, I expect to see traffic to or from the server that is on the source port, in addi...

Hello, I have a question on "directly connected, via Null0". I am searching the web, but also wanted to get your inputs. On a router i have ospf running and under ospf summary address of 166.177.234.0 is configured. Now, let's say when i do " sh...

Hi,I just recently purchased a Catalyst Express 500 switcha dn for the life of me I can't get the intial configuration page some up. Any thoughts? I went throught the getting started guide and all I get is page can not be displayed.Thanks in advance ...