Switching

I have a 3750G switch (IOS 12.2).  I've got a server on a port off of this switch that sends out multicast traffic, but does not apply any QoS settings.  I'm trying to figure out how to add CoS or DSCP to all inbound traffic on the port (which is on ...

from a computer behind the 5505 ASA, I cannot access the internet. Copy of my config below.Thanks in advanced.Bobbyinterface Vlan1 nameif inside security-level 100 ip address 10.200.1.17 255.255.255.240!interface Vlan2 nameif outside security-level 0...

Hello,Still not sure how I did this even after looking at the log files which are below.  Anyway we have a LAN which has 2 Nortel 8600 Core switch which are trunked together (IST - Nortel Etherchannel).  Off each Nortel are etherchannels to 2 Cisco 3...

Hi Community,I'm facing some problems and I'd like to share with you to check if my understand is correct or not.I'm attaching the topology to help with the understanding.In normal situation, traffic is able to pass from the 5K to the 6500. However, ...

                   I want to set up Multicast with multiple Auto RP. I Basically have two RP that need to be able to multicast information to all of my routers.  Can i do this and use ip pim sparse-mode or does it have to be sparse-dence mode? I dont...

Hello,Maybe someone can help me figure out the issue I'm having?  We have 2 x 3750 switches stacked, one of which is our Default-Gateway or what we call the CORE(SwitchA) and the other is just a stack(SwitchB) without routing that is connected with a...

Good morning Dears:-I have a problem with router 2800 series the when rebooting after power failure it boot on ROMMON mode ......!!!!!!I neet to make restart again maneual to start normal may be one time or twice time .....!!!!!!!!!what that mean ???...

Hi all.Today i decomissioned a switch from my 3750 stack. Upon recabling my stack i have lost a member from the pool. The switch is operational and performing as normal but is missing from the stack. Upon closer inspection it appears a port is down. ...

Was surprized to find out that 12.2(46)SG has MQC QoS, so no mor LAN QoS.Very good, long time awaiting ...QoS configuration page for 45oo Sup-6 is very simplistic and does not really open up the differences between long existing MQC on routers and MQ...

I have upgraded a Cisco 4506 with a Supervisor 4 to a Supervisor 6-E and low & behold, my CoS/QoS settings no longer work.  I see from a white paper that Cisco upgraded the supervisor capabilities to MQC, which is more inline with the IOS routers.  T...