Discuss Catalyst brand switches with peers and experts.
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

I have a customer who recently replaced their (2) Cisco 2600 routers configured in an HSRP with (2) ISP links in an ethernet hand off Active/Standby with (2) Cisco 3750 stacked  switches.Interface vlan 2201ip address 28interface gigabit...

abbas.ali by Beginner
  • 1 replies
  • 0 Helpful votes

Hello,I am trying to configure VACL capture on switch WS-C3750X-24T-L (IOS Code – c3750e-universalk9-mz.150-1.SE2.bin).ip access-list extended IDSpermit ip any any!vlan access-map IDS-mapaction forward capture                                   <<< no...

Hi,I was assigned a task to connect two locations through a L2 VPN.The infrastructure which i have are...Fortigate 80 C firewall at Location ACISCO 3560G at Location ACISCO 3750G at Location B2 MBPS Leased Line connecting two locations.T1 line at Loc...

After weeks of research, I give in and need help. My setup consists of a Charter Cable 30MB link on a Cisco 3008 modem --> Cisco 3825 (c3825-adventerprisek9-mz.151-4.M5.bin) --> Cisco 3550 (c3550-ipservicesk9-mz.122-44.SE6.bin) and I use CCP 2.6 to c...

Dear all,kindly i need your help in designing this topology for hospital i have 5 floor in each floor i have :first floor :83 network pointsecond floor: 140 network pointthird floor: 85 network point4th floor: 25 network point5th floor: 27 network po...

ASCompany by Beginner
  • 19 replies
  • 0 Helpful votes

Hello all,So i've read this doc so many times trying to sort out a specific part of it, and it is about this statement (i've highligted in red the parts that aren't making any sense, and my comments are in paren in black between the highlighted red):...

Hi All,I'm quite new in switch stack and switch cluster topic, but for my curiosity to know about it i read it for the first time and understood some basics, I might not have understood whole concept at a strech, but i want to know more about this tw...

shahhardik by Beginner
  • 6 replies
  • 0 Helpful votes

Hi,A switch keeps giving below messages ;%OSPF-5-ADJCHG: Process 77, Nbr on Vlan101 from LOADING to FULL, Loading Done%OSPF-5-ADJCHG: Process 77, Nbr on Vlan102 from FULL to DOWN, Neighbor Down: Dead timer expiredthe configu...

suthomas1 by Frequent Contributor
  • 1 replies
  • 0 Helpful votes

Hi,We are trying to ascertain how much bandwidth in Mbps or Gbps is flowing through a device. This different vendor device only shows packet per second rate in its interface.Can someone please help on converting pps to Mbps or Gbps.Thanks for inputs!

suthomas1 by Frequent Contributor
  • 3 replies
  • 0 Helpful votes