Buy or Renew
Buy or Renew

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

Resolved! Secondary IP Address and DHCP

Hi Friends,I've configured my router LAN interface with secondary IP address, with & without ip-helper address.Option (1)interface GigabitEthernet0/0 description *** To LAN *** ip address 192.212.32.1 255.255.255.128 secondary ip address 192.234.212....

NAT between inside and dmz

Hiwe have core switch in our network connected to ASAon switch ve have vlans:vlan 20 inside   ip address 172.20.20.0vlan 30 dmz     ip address 172.30.30.0interface vlan 20ip address 172.20.20.254interface vlan 30 ip address 172.30.30.254ip route 0.0....

Resolved! 7600 stuck in RoMMon

I have a 7600 with ws-sup750 and when it boots it displays these errors:Cisco IOS Software, s72033_sp Software (s72033_sp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SXH2a, RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyrigh...

WISM requirements for VSS

Hi all,I have the following on my 6509:Mod  Port Model              Serial #    Versions---- ---- ------------------ ----------- -------------------------------------  1   10  WS-SVC-WISM-1-K9   XXXXXXXXXXX Hw : 2.2                                   ...

tuan dang by • Level 1
  • 553 Views
  • 1 replies
  • 0 Helpful votes

HSRP | No Group!!!!

Hi Netprolet us talking HSRP,the blow config is it acceptable? no HSRP group for each VLAN!what is the pros and consinterface Vlan250 ip address 10.250.200.2 255.255.255.0 standby ip 10.250.200.1 standby preempt!!!interface Vlan251 ip address 10.251....

Resolved! Amount VLAN Supported,

Hi All, I have problem with my switch please help me ! I have cisco switch 3560X and I try to configure it with more that 2000 VLANs but I got an error as below. How many VLANs can cisco switch support ?Switch(config)#vlan 2-4000Switch(config-vlan)#e...

Pok LY by • Level 1
  • 1967 Views
  • 1 replies
  • 0 Helpful votes

Resolved! LAN Ethernet vs WAN Ethernet

Hi,I own a Cisco 892W router. The router has 2 WAN ports and 8 switch ports. Now I know - -WAN ports can create sub interfaces, assigne IPs, cannot be assigned to a VLAN - sounds very much like a routing port. (sh interface gives - Hardware is PQII_P...

Resolved! Implementing QoS on 3750 using MQC

Hi all,I'm attempting to configure Classification and Marking on our access switches using the MQC model. The Switches are 3750's running IPBase Version 12.2(35)SE. For some reason when I activate the policy-map on an interface, no traffic is being t...

wcc p issue

hi! I've the setup as per the diagram attached. I try to setup w ccp in our env. I noticed that the wccp command will only work on the interface level if i turn the switch port into no switchport. Here are the draft of the command. The objective is t...

dave dave by • Level 1
  • 2175 Views
  • 7 replies
  • 0 Helpful votes

SNMP on Cisco 3560

Hey,I have a network of 300+ nodes and I have started using SolarWind LAN Surveyor for the management of my PC's and Switch for that i have enabled SNMP on Cisco 3560 Switch but when i try scan my network through software than it only shows me Switch...

Questions on LACP and performance

I have (2) 3750E switches in a stack. I have a Windows 2K8R2SP1 server with (4) 1Gbps ports configured in a port-group. I have a FalconStor iSCSI SAN similarly configured with (4) 1Gpbs ports in a different port group. I have MRTG running. The SAN an...

Redundancy link setup help

Hi guys,Grateful if you could help me with the above subject. I want to setup redundancy between our sites via our ISP ADSL could without causing any loops, and i would like to know which technology will best suit our scenario. I've attached a networ...

Load more