Switching

Cisco Community,Your assistance and experience in this matter would be hugely appreciated.My client has a requirement to apply Policy Based Routing in their 3750 Stack Switch environment. In order to allow this I need to reconfigure each of the 3 eff...

We currently have a single stack of 3750Gs, running IP services. We have a leaf switch on one of our floors running 2 uplinks in a LAG (for a 2Gb connection), back to the existing stack.We would like to split the stack into 2 (for some redundancy) in...

Hi,Does any one have a recommendation on a good place for Nexus Training in New Jersey,New York area.Should we take a training course on 5000/7000 combined ?ThanksStan

I am having some issues finding the specific information about EnergyWise that I am after.Does energywise shut down the port? So If I have a energywise schedule on a port that does not have a PoE device will that port be effected?I have a few PoE dev...

Does VSS have more redudancy than HSRP because VSS has both distribution switches active instead of passive and active like HSRP?

Dear friends,Just by experimenting I have stumbled across the possibility of configuring and successfully applying VLAN ACLs (VACLs) on 2960 series Catalysts in IOS 12.2(58)SE1 LANBASE. However, there is absolutely no mention about this feature in an...

We tried to install a 4 port gigE card into the back slot and it didn't show up.Apparently it's saying that it can only support one gigE switch...is it counting the two onboard ports as that switch?Can I disable them to get it to recognize the card o...

Hi Guys,I have an issue whereby I cant seem to get multicast to stream outside a vrf.I have the following scenerio;6500 switch, sup-720 loopback set as the rp.I have created a vrf (lite), which is sat behind a fwsm. I have enabled multicast routing i...

Has anyone configured one of these?  I can't find any information about how to configure the VDSL controller, anywhere.I have one, hooked up to a VDSL line, ready to configure.  Now I can't find any information on Cisco's website about configuring th...

I have been searching but couldn´t find the forwarding rate of the 3560 v2 switches (expressed in mpps).Does anybody has that information?Or is there a way to deduce it from other specifications?thanks for your help.Sergio L.

I have a Catalyst 2960-48-TTL that I have a problem with when writing boot system flash:filename information.  I get a response of vb:: Read-only file system.I removed all other IOS images from the flash: directory except the one that I want to boot....

How can i setup a switch ethernet port to always send back what it received on the same port? Computer---->switch     switch always sends back the ata the computer sends it.Is there a route option for that?Thanks,Mark