Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Resolved! history buffer

hi every body!My book shows following commands:history size x (line configuration mode)terminal size X ( exec mode)If both commands set to diffirent number, which one will take precedence?Thanks a lot!

sarahr202 by Level 5
  • 7726 Views
  • 2 replies
  • 0 Helpful votes

HelloThanks in advance for any reply's to this.I have 4 stacked 3750E's in our datacenter. Everything is running fine, but on my firewall I see that the switch is trying to initiate a connection to my PC every second. The configuration doesn't have o...

Hello all, I have a 10/100//1000 WS-X6148A-GE-TX module. Is this module hot-swappable? Can I mount it without powering the switch off?Can't seem to find any information about it on Cisco's site.Any help will be greately appreciated.Thank you.Dmitry.

Resolved! syslog messages

Hi every body!My book says syslog messages are sent to console automatically. Any remote user(telnet/ssh) can view log messages by simply using the" terminal monitor" command.My question is if i telnet into router and " terminal monitor" command i...

sarahr202 by Level 5
  • 5634 Views
  • 8 replies
  • 0 Helpful votes

Hi allI am having difficulty getting HSRP working beween two 2811 routers. When I type 'show standby' both routers think that they are active, and that the other is 'unknown'.If I do a 'debug standby packets', I can see that 2811-1 is sending and rec...

I have an ASA5510 routing the VLAN's. 1 trunk comes from the ASA into a dell 5324 managed switch, out that into a 2nd 5324 switch, out that into a Cisco-Linksys SRW224G4. I can see all the VLANs on all the switches and they all are routed properly, e...

sobers by Level 1
  • 2425 Views
  • 4 replies
  • 0 Helpful votes

Hello,I'm trying to track down the physical switch that is acting as the Root Bridge for VLAN 2. From the output below I have found that 0221.5a6b.XXXX is the root bridge for VLAN 2. But this is a Learned/propagated address. So far I have looked at 1...

Hello All,I have a 6500 and an ASA installed. I need to proxy http traffic to a 3rd party Web filter before it hits the ASA. How do i accomplish this? Do i use WCCP? If so, what version?Thanks,G

Hello Experts,I have configured 100+ ACL on 6500. I see log of rules with matches but only few (i.e example 10 out of 100 matches ). And when i remove the rules which are not matches in the acl's the traffice does not go out of interface. It appears ...

we have catalyst 4506 and 4507 switches serving both voice and data.we have noticed that when soft rebooting a nortel 2004 phone it was taking 10 mins to reset.a trace on the switchport serving the phone showed numerous dhcp discover frames being ge...