Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|

Labels

Forum Posts

I came across one question where 1)Switch A uplink gi0/1 is configure as access port with vlan 10. There is one pc A connected to vlan 10.On the other end, Switch B uplink gi0/1 is configure as access port with vlan 20. There is one pc B connected t...

Hi,Ive created Primary vlan and ive associated secondary vlan to primary vlan on an 6509 ios .In Primary vlan ive given the ip address and secondary vlans has been associated with different customers respectively having a common gateway ie primary vl...

madanhari by Level 1
  • 334 Views
  • 1 replies
  • 0 Helpful votes

We have a frame-relay network and 2 sites have layer 2 connectivity. On each interface we have "frame-relay map ip x.y.x 201 broadcast" Why do we have to define neighbor inorder for the ospf to connect?our interface is setting at:Serial1/0 is up, l...

I have a cisco 2950 that I can console and it has no user name and password and ip set at 192.168.1.200When i use the cisco network assistance for the equipment it ask me for user name and password and it will not let me in if I use blank Do I need t...

Good afternoon!Just a quick question, what is the command in IOS for presetting a command so that it can be executed in a certain time point later? it is not reboot the switch.thanks,Han

wuh by Level 1
  • 254 Views
  • 1 replies
  • 0 Helpful votes

1.In SH IP PROTOCOLS:- where/what is the OSPF area? where is the OSPF Routers ID of neighbours, Are there timers in EIGRP?2.In DEBUG IP OSPF PACKET:- what is chk:8074, aut:0, auk: from Serial 0/2/0.How do we know it'll be SENDING Hellos in this comma...

aqusingh7 by Level 1
  • 448 Views
  • 1 replies
  • 0 Helpful votes

I keep getting these messages and am unable to load my 12.2 IOS.System Bootstrap, Version 5.2(8a), RELEASE SOFTWARECopyright (c) 1986-1995 by cisco Systems2500 processor with 16384 Kbytes of main memoryF3: 15025024+968980+947240 at 0x3000060** Image ...

Hi, I have been told that we need to shutdown all unused ports on all the switches. Since this is a lot of work, I have thought about giving this task to the helpdesk but I am afraid of them making a mistake; therefore, I would like to see if there...

hi if i give sh clock it clearly give the IST current time, but in the log messages will display as 5 1/2 less ie.if the IST time is 10 pm if there are logs it show as 4:30pmany guess!!!

Hi allJust a little question about ospffistly, when we talk about neighbours, does it only form neighbour relationships with directly connected routers, and will only directly connected neighbours show in the neighbour table?and secondly when we talk...