Switching

I am trying to get some backup for my existing Lab Gateway (7200). I have another 7200 that I want to use to setup as the backup Router. I have never done this so I need some help. How do I connect the two first of all and then how do I set it up. I ...

Good day,Could you please let me know the warranty length of the following part#s? My customer is asking for it. ThanksCISCO2811-V3PN/K9CISCO2851-SRST/K9CISCO2801-V3PN/K9CISCO2811-CCME/K9C3825-VSEC-SRST/K9WS-X4648-RJ45V-EACE-XML-FIPSIPS4270-20-4GE-K9...

Experts,I need urgent help with my network design. I have put forward 2*WS-C3750E-24TD-E switches in the design. I have ordered it and now have found that it comes with 265W power supply. The problem is I have also ordered PWR-RPS2300 with 2*C3K-PWR...

My new router (identical to an older one) does not allow me to configure mmi. Keeps returning the "invalid input" for mmiHere is my sh verIVR-2801B#sh verCisco IOS Software, 2801 Software (C2801-SPSERVICESK9-M), Version 12.4(15)T5, RELEASE SOFTWARE ...

i able to create below sample (Can ping each other). The problem is how to let my clients PC to communicate each other? i have try to create Vlan, but not success? Any1 can give some advice..Thxhttp://www.cisco.com/en/US/tech/tk365/technologies_confi...

we find some ospf notification log on our core-switch like below:Jul 21 07:15:56.167: %OSPF-5-ADJCHG: Process 1, Nbr 202.165.96.216 on Port-channel3 from FULL to DOWN, Neighbor Down: Dead timer expiredJul 21 07:16:03.227: %OSPF-5-ADJCHG: Process 1, N...

All,We have a 6509 with Sup720 running 8.6(4). We configured two GigE port 2/13 and 2/14 as trunk allowing VLAN 101.We want to apply a policer to limit traffic on 2/13. Below is what I did:set qos enableset qos policer microflow MIC-P1 rate 100000 bu...

Hi,I want to perform static NAT for multiple source IP address to a single IP address, how can I perform that or is that possible and what is the alternative.Thanks in advance.Yamin

does ws-3524-xl-en support qos, we have a power brick for this device, if it will support it what ios version should I use?thanks again appreciate the help!

If you have a pair of 6500's running VSS with your VSL link on a seprate line card not the sup engines can you pull out the standby supervisor and continue to pass traffic on the switch with the pulled sup?

Hi,I want to translate destination IP address on the outside interface of the router (i.e the connection is initiated from outside and the destination is the internal IP address), i want to perform one to one translation i.e static NAT. Can someone t...