Switching

Hi allI have a GigE trunk interface connecting two 6513. On one of the 6513 the "Total output drops" is constantly incremented by 7000 an hour. Total packets outbound is 118000000 an hour.I know outbound drops might be caused by burst traffic but is ...

How do you back out a set port channel group (port) admin_group? I started to set the admin group for a couple of ports to get them ready for etherchanneling and now I want to clear the admin group designation for those ports as I will not be etherch...

Hi I would like configure VMPS, and I have the following questions:* I can set the VMPS server in a 3750 switch. What model soport VMPS server?* In the client VMPS switchs, I can configure the access ports with vlan static and vlan dynamic in the sam...

I enabled ip cef on one of our 1760-VPN/K9-A routers using 12.3(1a) IOS. Just wondered if anyone is aware of any issues with this IOS and router which might have caused this.

hi all,can someone tell difference between CAM & TCAM.Thanking you,prashanth

I can't seem to get past the Eth0 of the router when I am on the switch, however, when I am consoled on the router, I can ping everyone and their mother. I don't get it. I'm hoping this mini graph will help. I also have the FA0/2 set as a trunk b/...

Is anyone using a /31 mask on point to point links or uplinks between layer 3 switches? Is there any downside or gotchas? I'm planning on running layer 3 all the way to my access switches and using routed ports to connect the access to the distribu...

Hi I am Managing Network of Campus Lan,where i need a good syslog server to maintain 6500 switches and 4500 switches and ASA,Router I need some Open Source Software so that it will be helpful for me

Hello -I have a 3750 stack with routing enabled. I have two vlans, one for management and one for the office PCs. I can access the management from the switches if I telnet from one to another, but I am unable to access the switches via telnet from an...

Hi All,I have implemented VACLs for capturing vlan traffic and all works fine until i add a second capture port on the switch. The CPU rises from about 10% to 75% and the latency when pinging a device on the local net goes from <1ms to over 40MS. on...

All,We are connecting 6509 hybrid mode to aother device with a six ports LACP trunk allowing VLAN101. The LACP is up on both side of the channel. We passed traffic with mixed MAC src and dst addresses. But we found traffic was out of 6509 only on one...

Hi Experts, I would like to forward the traffic between 3845 and 7206. the problem is that 3845 and 7206 does not have fiber ports so i am using 4506 to connect them. PPT attached for the reference By defalut the 4506 will not forward the traffic to ...

My labb switch is unable to boot automatically.The BOOT environment variables needs to be set to a bootable image.How is it done. I am not a Unix expert. I NEED HELP FROM AN EXPERT

I have a non-cisco application connected to a 6500 server farm switch port gi0/2.I notice that if this command "Spanning-tree guard root" is not in the interface, it will not work.What is the reason behind when this application is not going to be ele...