Switching

Hi All,We have WAEs between 2 sites and would like to take out all the commands and the equipmwent from network. Commands added on both end routers (RTRA & RTRB:Global config mode: ip wccp version 2 ip wccp 61 ip wccp 62Interface mode: ip wccp 61 r...

After implementing 802.1x port security on a native IOS Catalyst 6500 switch with redundant supervisor we received the following repeated error:%SIBYTE-SPSTBY-4-SB_EXCESS_COLL: Excessive collisions on mac 1 followed by : %SM-SPSTBY-4-BADEVENT: Event ...

Hello,I'm wondering how I can shape my outbound traffic?I'm sending over SCP from a pc 192.168.1.136 to the internet and would like to limit this to 20kb/sec.How would this be done?

Hi,I have 1800 series NAT enable router. F0/0 have primary (local lan ip) and seconady ip (valid pool ip).My nw is working smoothely but sueddenly in each 4-5 days some users unable to access the internet. As i remove the statis nat cmd from router a...

I have a 3750 connected with a 2960 catalyst and a 3com switch.There is 6 vlan configured.I can communicate between vlan perfectly.However when I ping under windows command prompt from the clients, the result is different.From the 2960 the clients ca...

transparent mode VTP - the local vlan database is not propagated out to other switches.....ok.... therefore if there are several switches trunked together, running VTP transparent mode (802.1q) - will all vlan traffic be sent out to all the other tru...

I have a 6509 with a Sup 720. In the log I am getting the following error messages. cat6509-1-msfc-dc#sh logSyslog logging: enabled (0 messages dropped, 136 messages rate-limited, 0 flushes, 0 overruns) Console logging: disabled Monitor loggin...

How do I go about restoring a catalyst 3750 to its factory default settings? I has a configuration on it but I want to bring the catalyst back to its out of the box condition./

Hiwhile trying to fire ISDN from one of the access locations using DDR and using icmp , the call is established and i can see using debug ISDN commands like debug dialer events and debug isdn q931 , the o/p shows Multiple Frame Established at Layer 2...

we are using cisco catalsyt and have mangement interface configured on it with all ports in VLan 1 (default Vlan)IP assigned to management interface is say for example int vlan 1ip addr 172.16.20.253 255.255.255.128the PCs attached to this switch hav...

Hi all, can anyone tell me what cable i need to connect 2 e1 controller interfaces back to back ?

For the 6500 Sup720, there is a choice of ipservices with SSH, and ipservices with SSH LAN only. What are the major differences in the two?