Switching

Hii Team,    I have one issue. When I connect my Cisco switch directly through console cable it logins directly without asking any usernam and password in the putty. And I have assigned ip to the switch as well to login through gui.  But when I try t...

Maybe this is a stupid question.I understand STP, but if there is STP, why do I have a loop and lose my connection via console and is it necessary to restart the switches to fix the problem?ExampleI need to install five switches.I'm guiding the techn...

May 25 03:28:11.076: %SW_MATM-4-MACFLAP_NOTIF: Host 4611.9d95.39bc in vlan 1 is flapping between port Gi1/0/4 and port Gi1/0/7 May 25 03:26:30.514: %SW_MATM-4-MACFLAP_NOTIF: Host 4611.9d95.39bc in vlan 1 is flapping between port Gi1/0/4 and port Gi1/...

Hi,I'm having difficulties with the relationships between (R)STP port roles and states and which works with Uplinkfast. STP port roles: Root, Designated and BlockingSTP port states: Blocking, listening, learning and forwardingCan all port role types ...

I am trying to configure a banking enterprise network. Just started. So, I put a switch in each department. A specific vlan for each. I have configured the layer 3 switch ports with vlan 10 and vlan 20. and given them ip addresses as well. And I am a...

Hi experts ,  If the server is set to 1500 MTU and the GigabitEthernet port on ACI Nexus switch is set to 9000 MTU , would the traffic between the two drop completely ?

Hello,  I think I might an issue with SNR/RSRQ. Based on what I know from my radio days different equipment can have different thresholds, but their are standards that are good practices. For this particular router I am trying to find Cisco specific ...

Hi everyone We were just trying to understand, what´d be the total switching throughput capacity by using only 2 members of switches on a stack? What would be for 3 switch members? As per documentation, Cisco says that we can stack up to 9 switches (...

I am trying to install licenses generated by the customer on a 2-switch 9516-A stack.  The customer provided the tokens for each switch, and then I built the license file as shown below (serial numbers are redacted):   <smartLicense><specificPLR><aut...

We are looking at purchasing the CBS350-24P-4G but due to supply chain issues, only the CBS350-24P-4X is available. We will be using a fiber trunk link between this switch and a SG350-10MP. The SG350 only supports 1G SFP. Can 1G SFP's be used in the ...

Hello All, I'm trying to enable Openflow on a Cat 9300 Net Essentials  running ver 17.3.3 and have been able to boot into Openflow mode however when I tray to add the Feature command it doesn't exist in the command set.  Looking up feature list 17.3....

2960 Plus Series Model Switch WS-C2960 +24TC-L cannot enable the REP and Nor CIP function in the default Vlan.   The problem that I am facing is that using the Supervisory automation system: Indusoft + CLP + Cisco 2960 Switch we are experiencing slow...

Please help - is there a way to establish a fault tolerant connection between the 4321 ISR router and the 2960 or IE2000 switch?Writing bachelor's work, doing a simulation at Cisco Packet Tracer. The HSRP activation command is not accepted by the sim...