Switching

We are looking at implementing QOS on our network and are confused on exactly what can be achieved with these switches, our supplier tells us that you can't mark outbound packtes you can only mark inbound packets but reading the 2950 docs it gives th...

Hello AllI have network setup like,CLOUD---CISCO 2621----SWITCH---(LINUX SERVER & CLIENT)I have configured HTTP (Apache) on linux server, its working fine from out side the network. But if suppose i type mydomain.com from internal network than it dos...

Hi,I have WS-6724-SFP cards with and without DCF3B daugther card in the same chassis. How will the fact that some cards have DFC3B and others do not affect the forwarding performance?For exemple, when I have Etherchannels configured that use ports in...

I am currently running Smoothwall and a Cisco 2611 router on my network.On my Smoothwall, ifconfig -a is:eth0 - 192.168.1.1 - greeneth1 - 192.168.5.1 - orangeeth2 - xxx.xx.38.35 - redOn my router, show run is:fa0/0 192.168.1.1fa0/1 192.168.2.1router ...

We just install a NAM-2 on a Cisco 6513, after session into the NAM and configure IP address default gateway, enable HTTP server. NAM can only ping itself, we even can't ping 6513 and gateway. The show IP command shows the right configuration. Accord...

IM RUNNING MY ASA IN TRANSPARENT MODE BETWEEN 2 SWITCHES, CAN ANYONE TELL ME HOW TO ALLOW BPDU'S THROUGH THE FIREWALL ?CHEERSCarl

We have newly bought 7609 and 7613 routers.In these routers we have added a 512MB DDR Ram additionaly and 2x128MB flash memory.I would like to know by which command we can check the additional RAM and Flash memory.

Hi All,I could have sworn I asked this before, but I cannot find in my posts...so I apologize if someone has already answered.I will be putting in a video conferencing solution at my central site in the up coming months. Where I need some direction ...

Switch 2950, do I need manully to insertthe Clock timezone - local time

now ,when started the 6509 auto enters into ROMMON mode. when started ,it prompts:(slot 5 is sup-720 moduel)FABRIC-SP-5-CLEAR_BLOCK: Clear block option is off for the fabric in slot 5.00:01:18: %FABRIC-SP-5-FABRIC_MODULE_ACTIVE: The Switch Fabric Mod...

Hi all, I was looking at my book yesterday on frame relay, is it right that if you congigure it on a serial interface ie s0, you only need to put the encapsulation in if it supports inarp? can we do this if we have multiple dlci's or would we have to...

I would like to restrict 192.168.1.x in a routed network from only getting 512 MB of Internet access while users on 192.168.6.x have full bandwidth access. Is there an easy way to do it? Both IP addresses are subinterfaces on my LAN side, and the WAN...

hi, We are planning to have 6513 at our data center along with the FWSM , IDSM and DFC modules . i have a question regarding the same : I plan to use MSFC in front and then fwsm .. 1.in this case does all of my dfc will be like L2 switches and even t...