Switching

Dear allI am facing the problem to configure inter vlan routing according to the attachment diagram. If possible send me the configuration RegardsImran

Hi all, I need some help on the 877.Currently, my setup is using the 877 with 0/100 VCI/VPI.Recently, I need to add another VCI/VPI 1/100 for IPTV service.This interface will negotiate for an IP address through 1/100, and needs to be directed to the ...

The carrier terminated the line on a Chrone Block and gave me the pin-outs on that punch-down block.So I made up a cable and connected that cable from that Chrone Block to the Rj45.With the following outputs, can I assume my cable pin-outs and connec...

I keep getting this error message when I try to get into the switch through hyperterminal. What does this mean? I upgraded the firmware to v5.37. Previously I was getting an invalid firmware error in diagnostic mode prior to the upgrade.

Hello,I have a Cisco 7206, running NAT. I am tanslating our internal network range to a single 'public' IP address. We are also running VOIP on our network. The router is runnig version 12.3After about 1-2hours, sometimes less, the router will just r...

Hi,My NMS send SNMP time out message from the host which is in a diffrent VLAN other than the NMS.I did't find anything wrong in my network and it seems to be no delay between these two.Please help me how to find out the resoluation for this issue.FY...

PLEASE HELP. We are trying to connect a Supervisor IV [Cat4506] via 2 GBICs to two SFPs in a 3560G. No matter what we try, the links on the 3560 do NOT stay up!! Has anyone seen anything like this? THANKS!!!

Hi ;I have a setup where i need to implement load balance on 2 routers in both sides ,LAN and WAN , and there is ASA in the LAN side , my question is that when do load blance in LAN side using GLBP how the 2 ASA's will act on this because they will ...

Which Catalyst will replace the 3550 12G (core switch), so all the downlink switch will communicate via gigastack to the core switch? If not what is the alternative?

Can we use the normal copy flash tftp / copy tftf flash commands for IOS image transfer to 3750 switches instead of the archive commands.thanks in advance

I am trying copy startup-config running-configThe above command is failing with an error.User Access Verification Password: MLS-77-1>enable Password: MLS-77-1#copy startup-config running-config % Copy to running-config failed because configuration ch...

Hi i am studying for the CCNA exam. Can you only have a subnet per interface? Or can you have multiple subnets on a single router. Thanks

we have 30 pc,s which is the best broadband to use.net use will be 24/7.average download/month is 1.7GB.and the device.