Switching

Hi ALlI have two cisco routers connected over E1 via two serial interface on each other , I wants to limit B.W on the serial interface .Thanks in advance

I have a 1711-k9 router I am going to use for VPN. I have configured Fastethernet0 (the WAN port) with no problem. Its just standard ethernet.My problem is, that the LAN side is going through this WIC-4ESW switch.I am sure it is a wonderful tool. But...

I need to upgrade some 3550 switches to 12.1(20)EA1 Is the process of upgrading the IOS the same as say with the 4507's? Never upgraded the 3550's before. Thanks.

Ok...I said yes to erase the flash when I was moving a file into the router. Now, how do I get a bootable image back into flash? I am connected through telnet and am at a rommon prompt. Thanks - Wayne "eraserhead"

Can anyone tell me what the number in parens and letters mean in the version numbers of the IOS on cisco devices.ex: 12.3(7)T and 12.3(4)XD

Hi,I am trying to enable broadcast control in my network.I am using layer2 2950 and 3550 switches.someone please tell me what is the ideal packets per second must be set on a particular interface.by default it's rising 500 and falling 250.When i set ...

This is the small part of the network design that i want to seek advice from the forum .++ we have two cisco 2950 switch switch1 ==gigabit trunk == switch2 .we want trunking to enable between these two two switches by using there gigabit ethernet...

hi can anyone explain me difference between switch stacking and clustering though its very stupid question but i wnna make it clear

I admit, this is basicbut after reading thru the 3750 PDF I never could find information stating exactly where/how the global/stack-wide IP address is assigned.Is it the IP address assigned to VLAN 1 of the switch that powered up first? Can someone c...

hello all,i'm new in networking. is there any vsat configuration reference or books from cisco like how we configure a vsat modem, and connect our router to connect to it? just for my home lab ; )thank you,dedy

A client has outgrown their current workgroup router. They are approaching 250 workstations and their current DSL router will only handle 254. Can I get some recommendations for replacement? Specs are DSL WAN Internet access(max 1.5 mbps), should be ...

Hi,I get the warning message "Cookie information is corrupt" on one of our routers (Cisco 827).It boots up in rommon and I am not able to boot up IOS. I have tried to install a new image using TFTP, but I get the same error message when I try the tft...

We have just received a Cisco Security Advisory re. the misformed BGP packets and we're having a hard time determining whether the IOS on our BGP routers is affected. We happened to be running the IOS 12.1(5) and this specific IOS is NOT on the list ...

Hi Friends, I am a newbie, my question can make u laughing. I was trying to install DHCP on an router and i plugged the straight thro cable into the Ethernet interface of the router. Fortunately i got the ip address from the range i assigned. ...