Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have Layer2 cisco WS-C2924-XL swicth and 2620 routerI want to enable intervlan routing between two vlanSample1- 10.1.254.0/24sample2-10.1.253.0/24Swicth1#vlan databaseSwicth1(vlan)#vlan 2 name sample1Swicth1(vlan)#vlan 3 name sample2Swicth1(config)...

rangap26. by Level 1
  • 1653 Views
  • 11 replies
  • 0 Helpful votes

hi all, can anyone give me a description what this is, i have done a search but still arent sure, is it a protocol like tcp/ip ?

I have a 2610 router connected to 2 networks via ethernet 0/0 and ethernet 1/0 and I have a problem with one access-list. Both networks are connected via switches and there is a DSL router on one switchport with the ip address that is the default ga...

davef2000 by Level 1
  • 744 Views
  • 4 replies
  • 0 Helpful votes

Hi i recently we brought 3 2FE2W-V2 network modules. i have a tipical problem if i gave one ip address to once interface it will work if i give the same pool of IP address it will not work it is showing interface up Protocol UP but i packet loss . if...

rsjavahar by Level 1
  • 580 Views
  • 2 replies
  • 0 Helpful votes

Hi,I want to configure vpn between two site.Each site has two trafic: One for vpn and remain for internet connexion.I use for that cisco 837.Does me configure GRE trafic in the two router for that?How to make two type of trafic: whith two acces list ...

Hi thereMy switch is Catalyst 6509. I have 2 ADSL modem-routers that has 1M download speed each. I would like to "combine" both download speed so that I get 2M. Each ADSL modem-router connects to end PC using LAN cable. Is it possible to connect two ...

Hi! I have an older 806 router here, which gives errors when rebooting. A capture (by hyperterminal, see attachment) shows that after a reboot, a "watchdog" resets the device again.It was doing this before, and I thought maybe a broken IOS, so I mana...

I have a 2821 router with a hp switch connected to 0/0 and 0/1. Both switches have a pc connected, but I cannot ping from pc to pc. Doing a show arp in the router shows both pc's, but a show arp in either pc does not show the other pc but it does sho...

What is the default spanning-tree mode on a 4507 swith with IOS version 12.1 and later. Is it PVST+ ? The reason for the above stated question is that for the same category of switches with IOS version of 12.2 and above, when we run the "sh run" comm...

harmanrms by Level 1
  • 16465 Views
  • 2 replies
  • 0 Helpful votes