Add a "Server-PT" to your Network connected to the VLAN with IP Addressing of 192.168.2.0 (This should be where your "PC_West" systems are.)Label the Server "WebSrvr"Make the page state your name - Icon in addition would be coolStatically assign the ...
On a Stratix 5700 series switch running IOS 15.2(7)E, under the fast ethernet interfaces we enter the following port-security stanzas:switchport port-securityswitchport port-security maximum 50switchport port-security violation restrictswitchport por...
Hi, I have a problem with a Switch 2960 and a telephone Avaya, its activate the command port securit, the topology is Switch 2960 port + Avaya telephone + PC and the configuration the port is: Interface FastEthernet0/16description P...
hi all,we have purchased from an old company 7 3850s which are stacked together, they have flattened them so we need to configure them all againi know how to configure/set up individual cisco switches, so my question is, do i need to console into eac...
hello, i see error on FEX FAN: show environment fex 125 fan Fan Fex : 125: ------------------------------------------------------ Fan Model Hw Status ------------------------------------------------------ Chassis N2K-C2232-FAN -- failure PS-1 N2200-...
Hi I just installed switch c9500 with the default version 16.12.04.I don't understand the smart license, what I want to ask:- Is smart license mandatory?- If not registered, how long is the evaluation period ? the switch function cannot be used ?* F...
Hello,for our Meraki environment we are planning to replace our old non PoE switches to the brand new Cisco CBS250 series.As I know the Meraki MR46 AP 30W power for booting and operating. I am not sure and I won´t understood it wrong. On the CBS250 s...
Hi, I am interested in the following scenarios for a system with ISE as the authentication server: 1) There are 2 endpoints attached to a single interface configured for 802.1x. Both require 802.1x authentication (EAP-TLS)2) There are 3 endpoints att...
Hi guys, i wanted to know if there is a way to clear existing vty config on cisco devices like routers and switches?i was thinking of automating it using an eem script but i git stuck in the actual logic to use for thiswhat i figured was using the ou...
I bought a WS-C6509 chassis for a trainee and test lab, it was manufactured in 1999.I already purchased a FAN tray, two power units and 3 line cards (2x mini GBICs, 1x RJ54 ports). Now I bought a supervisor engine (WS-SUP720-3B). However, during the ...
Hello. I'm preparing to do some changes in my live environment and VPCs are new to me. I have a Cisco CML lab and I'm trying to setup a simple VPC configuration with two nexus 9000 series switches. I have a catalyst switch switch connecting an etherc...
Dear all,I'm searching for a switch able to cope with 10Gbit/s transfer rates (for a small, personal, cluster built from multiple workstations).Recently, I found this switch on sale: sg300-10sfp. I'm not sure it only works at 1Gbit/s or at 10Gbit/s.....
Hi sir, Can you help us to confirm the manufacturing month/year of serial number FLM2529072H is July, 2021 ? Thank you.
Hi all, I want to confirm the PSU of the chassis WS-C6509-E is faulty or not. So my question is, by look at the system alarm, its confirmed that the PSU is failed: - environmental alarms: system minor alarm on power-supply 1 power-output-fail (raised...
There are two 9606. Each has 2 Supervisor Engine 1.Is it possible to configure the cluster in between so that all four Supervisor Engine 1 are involved?If so, how do you do it? thanks
