Hi All, I have four routers connected to a PC equipped with four serial ports but the HPterminal can only reveal Comm1, which made it impossible to communicate with the remaining routers or even create HPertml for them. How can i locate the rem...
Perhaps someone can help me, as I can't find a clear cut answer anywhere as to how to do, what normally would seem like a simple task.How can I best forward http and https traffic to a host on the LAN side through a Cisco 1720?I'm essentially just lo...
Has anyone ever seen this: The 3500XL is not reporting all its memory no bin file?Directory of flash:/3 drwx 64 lost+found4 drwx 768 html682496 bytes available (2930176 bytes used)switch:
Hi,My company is looking at doing a converged data/voice project with all new Cisco equipment. Two vendors have given us quotes on the project, one is quoting the 3560 series switches (48 port 10/100 with PoE), while the other has quoted the 3750 wi...
Greetings, I have 3524 and 3548 Catalyst switches. I have performed some trunking on them like I have done many times before however when I perform a "sh vlan br" I notice that ports are not assigned to the vlan 100? is this normal? See config attach...
I am trying to configure an 802.1q tunnel across a 6506 switch with sup720 however when I enable "vlan dot1q tag native" I loose my session and cannot reconnect. What causes this?Please help.
I have a 3600 series router and 3500 series catalyst switch. VLANs were created by assigning subinterfaces in router. Since two days many of my interfaces are showing abnormal input rate which is above the resricted level[restriction made by rate lim...
I have a defective Catalyst 3500 switch, which can only boot into Diagnostic/maintenance mode.I need to extract the existing startup-config to my laptop from the defective switch and import the startup-config from my laptop into a new 3500 switch.Pro...
I "inherited" the responsibility of configuring a PIX device on a neighboring business' network. Now, our company wants to be able to send data to the other company's network, but the data flow needs to be one-way. I went about reading up on the prod...
The 6509 is not showing timestamps on its logs. It shows the uptime instead."service timestamps log datetime localtime" is set. The same goes for debug.The clock is set on UTC from an NTP server (per policy). Should this make a difference? If not, th...
