TelePresence and Video Infrastructure

Hi,   I'm having a bit of problems building a 3 server (v 2.9) CMS callbridge cluster. The DB cluster running in same three severs looks all good with all nodes In Sync. I have configured the Callbridges following the Resilient Deployment Guide 2.2. ...

Hi guys, throwing this question here as I have a TAC case going nowhere.I haven't found a single Cisco resource that has access to Webex Edge devices.... Even TAC. Anyone have both Cisco Cloud endpoints and Webex Edge Devices (DX70, DX80, Desk Pro, e...

Hello Buddies, I have a VC Cisco Room Kit Plus included these items: Touch Panel CS-T10-TS and Codec CS-CODEC-PLUS. I connected the touch panel directly to codec but on touch panel shown the issue "Could not connect to target system. Wrong target sys...

We have an Video Conferencing endpoint which is at one of our data centers and you have to be connected to a Data Center VPN to even connect to the VC endpoint. I tried Sharing content on a conference call from the particular VC endpoint located at d...

I have a project with a Cisco WebEx Codec Pro and the client would like to add a 12V privacy Titus light, would you know how many amps the GPIO 12v port offers?

Tandberg edge 95 is working fine with dvi to vga converter but  Not show anything with dvi to hdmi converter. Converter is working fine with another edge 95. Firmware is 9.3.4 pal

One phone 6921 not make calls through the asterisk Only one phone model 6921 is not a link to analog phones.6921 other phones make the connection There is a sip-trunk in CUCM going to the asterisk,look the image://In the CCUMCall Routing - Route/Hunt...

Since the new API guide (10.3) mentions not to use Key Click en Key Press anymore (and actually those commands doesn't seem to work anymore!) I was wondering how I will be able to show the Call page on a Touch 10 by external command?

Dear All, We are using the Cisco Webex Room Kit Plus.Codec : One x CS-Codec-Plus with Multi Site LicenseTablet : CS Touch 10 V04Quad Camera : CS-Quad Cam V01Whenever we have internal discussion with 3 rooms, the video is 4K at 6000 call rate with no ...

Is it Possible to add Poly X30/X50 and Logitech Rally Bar with TMS to Monitor.I'm trying to add Poly and Logitech devices with TMS, TMS is not recognizing the devices, Tho device is no network TMS is showing below message "System not found!Please che...

Hi there,I did recently upgrade codecs room kit and room kit plus to 9.14.6 Endpoint FW - I know now there is now available 9.14.7Proximity is Disabled at least its status is like that.What i have found is that when You use analog audio output in roo...

In the past without Cisco Expressway solution, employees behind internet had the need to use the VPN Client (like vpn anyconnect) in order to register their Jabber Client into the the enterprise’s Call Control CUCM which is basically and for security...