Hello Team , I am trying to register SX10 Device with CUCM but no luck In cucm status is unkwown and in sx10 - unable to communicate to remote server However ,I am able to ping sx10 and cucm both from switch . Can someone let meknow steps of co...
Forum Posts
Hello, I have a big problem with my SX20 telepresence, the camera can not finish adjusting, the remote control does not work (even with new batteries). I found an error in the network interface Can you help me diagnose the problem? I guess that the c...
Hello, We have a Telepresence SX20 running ce8.2.2. A recent penetration test has highlighted an issue with CVE-2011-3188 - TCP sequence number generation weakness. I am unable to find anything that suggests that this has been raised as a bug or re...
Hello- I am trying to determine if signal degradation happens when sending full motion HD camera signal through any of the content channels on the SX80. In a nutshell, can you force 1080p60 to adequately display at the far end when sending through 1...
Resolved! DX70 - no VPN?
Hi I'm trying to setup my DX70 to connect to dCloud using a VPN. According to the instructions, once my DX70 is connected to the Wi-Fi network, I should go to Setting -> More -> VPN. However, after connecting my DX70 to the Wi-Fi network, I can't...
we are planning for CMS 1000 two numbers & Expressway to connect to outside Need to know what is the internet bandwidth required for using the CMS 1000 on full capacity ? Per call how the bandwidth usage ?
Touch 10's connected to Cisco video codec systems running newer CE9.x firmware have a funky background where large color balls float in and around the Touch 10 display. Is there a way to disable this feature?
Hello, Within TMS for the TANDBERG MXP there was an option for 'OSD Menu CodecLabel' which allowed the Administrator of the unit to have a permanent label showing on the CODEC -- whether the CODEC was in a call or not. We used the option as our CO...
What is the Room Monitoring License for a IX5000, or does the IX5000 even support Room Monitoring? Room Monitoring lets you do websnapshots and the license is determined by the endpoint, SX, MX, Profile, Room, Room Kit, I'm not sure what the IX5000 ...
Hi, After swapping the normal hybrid camera cable on P40 with CAB-HDMI-PHD12XS on both ends, we lost the camera control on touch 10. Picture itself on camera is showing, only controlling of it is missing. Is there a limitation on Cat cable length or ...
Hi, Ineed to know if is possible to send de main screen of the Mx200 g2 to a second display , for example i need to send de camera of the othet participant to the secondisplay o repeat de same image in the teleprecence and the secon display.
Hello everyone, I have a small issue that I think know what's causing it but cannot seem to find a fix just yet. My telepresence devices cannot dial out using the usual Route Patterns and instead get sent to my SIP Route Patterns which end with the c...
Resolved! CMS invite link dialin address issue
Hi, I am doing a new deployment for CMS and everything is working except that when i go to the space and click on invite people and it provides me the webrtc link and dial-in address. However the dial-in address shows as @{firstname}{lastname}@doma...
Hi everybody, I am eatablishing Expressway MRA with CUCM CUCM 11.5Expressway X8.8.1EXP-E is using Dual NIC, one for internal, one for external Example: VoiceServiceDomain: production.comServiceDomain: lab91.local here is the connection CUCM ---(tcp...
Hello. Our customer in Swizerland has this machine and we are trying to access to their public IP address under H323. They said only SIP protocol is available but according to their spec. it shows H323 protocol also. Could some one advise me how to a...
