in an attempt to see if I had dual monitor support I changed the setting in video out put from 1 to 2 and now I just have a background. I cannot get any button controls except camera to respond.
any ideas on how to reset it to 1?
Thanks
Hi,
I'm trying to convert a WebEx meeting recording with the Network Recording Player and no matter quality or file format chosen, the status always changes to Failed, when reaching 100%.
Any ideas about what to do?
We will be moving to Google as our primary Email and Calendar, to make it easier for users we would like to give them user access to TMS Booking and Smart Scheduler.
First issue is when using smart scheduler the Time Zone is incorrect and I'm unab...
My organization is currently deploying a large number of SX20's to replace our aging Video Conferencing equipment, and I've run into an issue with the SX20's not detecting the presentation source.
Our standard configuration for the SX20 presentation ...
Hi All, I'm attempting to control a Tandberg MXP 3000 Codec via Qys Lua Scripting.I am struggling to read the Local Directory and can only see an xCommand to search through the Corporate Directory ( xCommand corpdirsearch).
Does anyone know of a com...
Hi,
I have 33 sites with video, but, I dont know if is necesary aditional bandwith depending of the layout on the screens. Aditional I need to know how to calc the bandwith to datacenter MPLS channel in where is allocated the Meeting Server.
1 Site S...
Hi,
Recently we upgraded MCU 5320 with 40 port licenses to Telepresence Server on the same appliance and in that process we converted these licenses to 10 Screen Licenses.
Now we want to re-host this on virtual TS and we ran into a problem with lice...
Hello There,
Can we add 2 additional content screen in MX 800 ?
I see this mentioned, but couldn't interpret it.
Video outputs(three outputs)
Two HDMI Outputs and one DVI-I Output; supported formats:
● 1920 x 1080@60 Hz (1080p60)
● 1920 x 1080...
Hello, I´m quite confuse regarding the VCS running on a CE500.
I never installed one of those but it says it runs on UCS-C220-M3L.
The install guide present a table with CIMC as future use and the procedure indicates that the KVM will lead to the VCS...
Hello, I am running version 9.1.2.10000-28 CUCM. We have 2 servers one Publisher and other is a subscriber. I am getting RTMT alerts all the time indicating phones are un-registering but the phones actually remain registered. In RTMT they go unreg...
Good day gentlemen... and ladies,
I'm trying to figure the best method for extending a Visca Control Cable for a Precision HD 1080p camera. I recently decommissioned several Cisco Profile 52" carts and disassembled the cameras, and now want to use t...
Hi Folks,I have some questions regarding the SX80 Codec.1. How can the requirement of the Cisco touch panel be shut off if the codec will be used in a room with a Crestron Touch Panel?2. Is there an optional remote control available for the SX80 in c...
