Question to the community out there. (Anyone done this or came across this before?) Running the preUpgrade cop file on my CUCM PUB still on 11.5 I get the following failure. Question: It seems this is only if you go to version 15, a version 14SU3 sho...
Forum Posts
I am with a school system and we have systems in place that allow each campus to be locked down (via controlled access) by dialing an extension "within" each campus. Each campus is setup like a hotel in that you cannot reach a classroom from outside ...
Hello Dears I hope you are doing well The purpose of this message is to know your interpretation to understand some details about the deployment of a MRA infrastructure, specifically about the records of the internal DNS server SRV's. In the docu...
Hello,iam currently trying to enable SSO on our CUCM/Expressway via Micosoft Azure.Cisco Unified CM version: 14.0.1.11900-132Cisco Unity Connection version: 14.0.1.11900-128Cisco Expressway-C version: X14.2I have followed the SAML SSO configuration g...
A change was recently made on one of our Rightfax Servers to use G.711 instead of T.38 and outbound faxes now drop at 15 minutes (change was made to avoid ongoing T.38 issues with transmission errors)We see the initial outbound invite where the fax e...
How to make it possible to view the incoming calls that are in the Attendant Console Standard queue?, since the operators do not see which one has the longest waiting time and provide the corresponding attention.I have CUAC version 14.02
Hi All,it seems network admin team has changed LDAP to LDAPS, do we require any changes in cisco call manager. best regards,yenosh
Hello,I have a stand alone CUCM 12.5 deployed in my lab connected to the SBC (ISR-4431 CUBE) and on the same SBC i have deployed a Polycom VTC Call manager.I have different dial-plans for each of them and they are both able to route calls through SIP...
cisco cucm BE7M data sheet and image i could not find. Please provide
Hi,While troubleshooting some issues, I noticed our Webex clients, registering using MRA through clustered Expressway E and Expressway C, are sending Register messages every two minutes. This may be normal, but this is creating an end point registere...
Hi team, unfortunately, I could not find the answer in the Cisco docs. I have a customer who wants to add a new location to the on-premises Cisco Unified Communications Manager (CUCM). The new location is quite large, and I want to install a new CUCM...
Hello,I'm new to SIP. I have CUCM v14 BE6k with managed SIP as our main phone service. The SIP provider sends us 4 digits. We are deploying a new IVR service which will connect over sip to our call manager. I need to redirect inbound calls from an ...
I am currently using my CME 8.0 router on my IPV4-LAN. I have two Cisco 7975G phones. Through using option 150 I can provide the IPv4 address of the TFTP Server to my two phones.How can I do this when using IPv6-addresses? There is no option 150 when...
When I have configured SIP-UA, I can see two registration requests are sent to ITSP. But only one SIP_UA is configured. attached image for reference.
We recently had an issue where the HA was out of sync.We broke HA and resarted the servers in proper order and re-established HA.Verified the BDs were happy. Now we find that our persistant chat rooms are missing in the jabber clients. BUT..... It on...
