Unified Computing System Discussions

Hi Team,I am building 2 nodes with Windows Operating System where OS has been installed on the blades and servers are reachable over the network. But we could not be able to get the HBA up to make visible in the SAN switches to proceed with Storage c...

Hi Team, We have an issue in our UCS domain where we have some MAC table is getting above the limit and the reason we found is because a VM mac address that is creating multiple entries in the table with different vlans(all vlans tagged to host vnic)...

Hello. I our Organization we have Cisco UCS C240 M5S servers with these sw installed: Firmware Version: 4.2(3i)ESXi Version: 7.0 Update 3i Currently the latest custom version of ESXi 7.0 available for download is 7.0 Update 3o (File name: "VMware-ESX...

Hello,I have setup running with 4.2(1n) with 2 * 6454 FI's and I am getting the frequent issue with UCSM GUI inaccessibility and restarting the pmon services to get the GUI back up online. Is there any permanent fix for this?This issue was there is a...

All, We have deployed many VMware vSphere / vSAN clusters over the years on UCS M5 and M6 hardware.  In those cases, the Cisco HBAs were always on the VMware vSAN HCL.  In the case of the UCS M7 series, the only HBA available is the UCSC-SAS-T-D, and...

Hi Team, Our team is working is new project where we are required to collect the power consumption data from the Networking and Compute domain. I am looking for a script or an efficient way to collect the data from the Legacy UCSM. I know the data ca...

Hi Team, I am looking for some power shell scripts where I can fetch the power utilization in legacy UCSM. I know the feature is available in IMM UCS but I need the data from the Legacy UCSM. Regards, Pranav Gupta

Hi experts, TLDR; How do I get the same information as shown in the screendumps below (of a UCS Chassis managed by UCS Manager) for our sparkling new UCS-X which can only be managed in Intersight? Specifically: How much power is being consumed/suppli...

Hello,I am working on some legacy gear which we do not have support for but are not ready to decommission. Two questions:Questions 1:Our FI's and blade are running on older firmware: 4.0(4d)Which does appears does not support 7.0.3, but is this irrel...

Hello,We are going to setup X series newly in one of our locations. Just wanted if there are any best practices to be followed and also need to know if this has to be set up in UCSM or IMM Mode as the datasheets for X series 9508 Chassis are having M...

We have a setup with a pair of fabric interconnects 6454 and few UCS 9508 Chassis running on UCSM mode. We are planning to add another Chassis which is UCS 5108 w/ M5 blade servers. Is this possible to be setup, and if so, can you share a document on...

Trying to upgrade a UCSC-C240-M5SN firmware from 4.2 to 4.3. I am using a vKVM mounting the ISO, have done over 4 others without issue, this one will mount the ISO, reboot let me choose it as a boot option, load the drivers, then right before it shou...