Voice Systems and Accessories - Small Business

HIPer cisco's website we purchased the MB100 wall mount braket for SPA 501 phones.  The phone does not line up correctly with the wall mount and sometimes falls off the wall mount as it is not securing well.  Is there a fix for this or another bracke...

Team,On our UC560 if someone tries to do call forward to an extension that has voice mailbox full, the call gets automatically forwarded to the operator extension(the one set for voice mail recording and such). Is there a way to tell the person that ...

I want to remove "are you still there? without changing the max retires.  What changes should I look for or what changes need to be made?  I just want it to repeat, but not play "are you still there?" prompt

Hello All,Just need a pointer here if anyone can assist.  Basically I have a SIP trunk setup on a UC320. It is setup as under outbound trunks so all good from what I can gather.  When I look at the Status Overview of the trunks it says registration f...

Hi,I have setup a a UC540 with the Night Service ability, in a multi-tenant environment. Two hunt groups (3 lines each) go to two different shared lines.We have setup the night service to go to their respective voicemail mailboxes after hours.Is it p...

Hi, I'm using a UC560 with about 20 SPA525G2 phones and everything went fine until the end of the last year. The customer wanted 500S extensions for every 5252G2 phone (until then only the secretarys' phones had those), so we installed them applying ...

Hey,Is it possibly to use a remote call to an SPA phone to tell it to start dialling a number? I'm looking to create a firefox plug-in that will recognise phone numbers and allow me to click to call, which will start the call on my desk phone.Setup a...

I like the all in one/pre-configured OVA option for UPM & VCS, but it limits my deployment options in that I need to have vSphere installed on a machine that is somewhat local to the UCS server to deploy the image with any efficiency. Downloading a 3...

We've just upgraded our UC540 to 8.6.1, which proceeded to totally wreck the whole phone system.After a number of failed attempts to recover from the half failed system, we've had to reset to system defaults and start from scratch.Whilst everything e...

Bonjour à tous,je souhaiterais savoir comment faire pour afficher mon numéro lors que mes appels sortantsmerci par avanceCyril

Hi,I have an UC560 system. I would like to schedule a nightly backup job to backup all configuration and voice mails. Is it possible? Configuration doesn't change much on daily basis but the voicemails do and need a way to back them up unattended.Ple...

Hi fellow members,Latest firmware installed 1.3.1, all incoming calls are dropped after the first ring and then followed by busy tone, all outgoing calls are fully functional. There is not much to say except that i followed all the ITSP config requir...