Voice Systems and Accessories - Small Business

Hi peeps, just wondering if anyone knows or has an opinion as to what number I should be using to dial and outside line. I was using '0' but now we are using '9' as i just rebuilt my UC540 from scratch with the latest CCA wizrd. i tried to keep as ma...

Have a BE-3000 not booting. When display and keyboard connected no indiction on display. Green Power lamp flashing.Any thoughts??ThanksPaul

After TS for hrs, we discovered that basically the LDAP (optional) configuration fails for no good reason, since we finally gave up with UPM and configured CUCM for LDAP, and it worked like a champ.           

I've got a configuration where we have an SRV record for the outbound proxy that the phones use to register and make calls.things work fine when the primary proxy is up, however when the primary is down I get interesting behavior.  The phone will com...

Hello,I made the upgrade to the new firmware in my ata spa 112 and after it doesn't register anymore... it alwasys writes" failed " on the voice registration in line 1 and 2... can you please help me ? thanks,Mario

Good morning.I have installed UC320W and Mediatrix 4402. I followed the guide for Mediatrix.I am able to make call with analog line , but i am not able to make or receive call with BRI ISDN.It possibile to use POINT TO POINT or i MUST user POINT TO M...

Just wondering if anyone has successfully implemented a single button Park user BLF & Unpark SD using any of the new Broadworks Call Park Enhancements that have been added to the recent SPA3XX / 5XX firmware loads.I'd like to have an unused line key,...

Hi,I am using Cisco SPA 525g, but when i apply DND from the terminal, it does not sync with the Broad Soft.I am using firmware: 7-5-3.Any idea, how to sync the DND with Broadsoft, when applied from terminal.RegardsShivam

Using the Plantronics Voyager Pro HD headset and finding that with the 7.5.3 firmware the phone thinks its connected to the headset but does not transmit audio.  Rebooting the phone corrects this or power cycling the headset.Prior to 7.5.3 was runnin...

Hello,My company currently uses a UC320 with a SG-200 switch....we are currently using a bonded T1 from Cbeyond and 12 SIP trunks for all calls. Since we are growing, we are upgrading our UC320 to a UC540, my question is, would this be plug and play?...

Hello.How can I change LAN IP Address on SPA8800?Default settings 192.168.57.0/24 interseсted with my VPN users subnet.Due to this fact I can't access SPA8800 from VPNs.

I normally use only daily schedule and the holiday schedule to control the night service on the system. Customer is asking how to make voicemail closed greetings to go into closed mode after hours, it doesn't seem to do it based on the daily schedule...

I have a SPA525G2 working on a UC520 running version 8. I have configured the set for SNR and have confirmed that mobility is in the softkey template added to the ephone. However the mobility key does no show up on the set. The system will perform th...

New UC560 installation.Client just informed us that they do not want to dial a number for an outside line, such as 8 or 9. Is there some way in CCA 3.2.1 to accomplish this?