Hi All,We have a customer who has a Polycom conference phone and would like to initiate a meet me conference. Is there a feature access code we can configure to facilitate this requirement.Many ThanksSteve
Hello, we have some old devices that we would like to connect over IP network.We have tried using 2 SPA3102, and the connection was successful(without using PBX software, just direct IP dialing) but, these devices use some special frequency to cont...
Hello, I've been digging around trying to work out how to set up caller id from incoming calls on any of the FXO's on the UC320 but can't seem to find the information in either the manual or in the web administration. Is this possible? thanks.
Hello,I want to to be able to detect a fax call that has come in on a pots line that configured to go to AA. While the prompt is being played without delay I want the fax tone detected and the call sent to the fax extension.I have read this fine docu...
I have a question regarding a UC540’s wireless and MS Vista. I recently started using a UC540 at my home and everything is working great with one exception; my fiancé's Vista machine will not connect over the wireless, well I will rephrase that; it w...
I have a few remote VPN Users with home phones but in different time-zones than the CME Router. Is there a way to set the time-zone on a per phone basis so these phones show the right time? I am running CME 8.5 on a 2801 router and these are 7965 p...
Hello, We have 2 different projects with UC500 8.1 & CUCMExpress 8.6 for 2 different customers. For both the end customers want to deploy Extension Mobility for all the users / phones. Questions : 1 - Is there known pbs to deploy full telephony with ...
Dear All,I have the following configuration, concerning Auto Attendand, running on UC540:dial-peer voice 502 voip description $AUTO ATTENDAND$ destination-pattern 298 b2bua session protocol sipv2 session target ipv4:10.3.3.162 voice-class sip out...
I have installed a few of these systems with great success using CLI and making changes using CLI such as phone assignments and any small configuration changes to users phones, etc. With the changes to the support, I started using CCA and have had p...
Hi,I was wondering if anybody could clear up a couple of points of confusion I have about the Smart Call Connector Toolbar?Is it possible to have it look up incoming numbers against Outlook contacts and display the correct name?I get the correct name...
i ave a uc 540 i use de cca 3.0the pakage annyconnectis is anyconnect-win-2.5.3041-k9.pkgi need to install ssl vpn for SPA525G but all pakage annyconnect is refused by the uc 540how to active the full tunel vpn or to install ssl vpn client on my uc5...
The UC320W 2.0 Maintenance Release 2 has been released. The 2.0.9(3) firmware is available on http://cisco.com as well as via the Cloud. To upgrade using the Cloud WAN Internet connectivity is required. Simply, log into the UC320W Configuration...
WHAT?The engineering team has been busy addressing a number of bugs (found in 2.0.6(10)) and will soon be ready for early adopters of the next maintenance release firmware via a “Release Candidate” firmware image. Release Candidate quality means tha...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: