Voice Systems and Accessories - Small Business

All,We have a paging group of roughly 40 phones.  2 of the phones included in this group are 7921G wireless hadnsets.  Neither of the wireless phones base stations intercom seem to either be configured or working.  Are the 7921's able to give an audi...

When we dial out of our UC540 to someone else that has a UC540 with a SIP trunk, we need to dial the local area code.  We have regular FXO lines.  We do not have to dial the area code for any other local number.  If you dial the UC540 SIP line from a...

Can anyone help? Can anyone tell me how to configure DID's on each SIP line. At the moment we have DID numbers, and each DID has a SIP account number. So for instance, on Line 1 we have account number of say 8XXXXXXX and that is entered into the USER...

Hi everybody,I am implementing a small setup for a customer with the UC520 and about 8 IP Phones. So far we have this problem where the customer wants to call forward all calls to their mobile when they are not in the office. This works fine with int...

Hi All,My next issue on the UC540 is the dialing a number for an outside line. In our test setup we have 1x FXO PSTN line and a SIP trunk. The Sip trunk has 10x DIDs and 10 lines.Now when we make calls we have to dial '0' in our case to get an outsid...

Steve D.  I posted this several weeks ago and had issues getting back into the community but now have my login back.  I am re-posting because I still have the issue.  I do NOT have a log for when the phone is booting with the sidecar.  I will try to ...

I was setting up a remote teleworker SPA525G and realized that our Server Activesync is communicating on the same ports.  Is there a way to change the ports on the UC520 and the SPA525G?  I would really like to roll this out, but it appears as though...

Hello,I am attempting to configure a new UCC Call Connect Server v1.6 installation. I have installed the software successfully and rebooted however now I cannot get the UCC Database Server Service to start successfully. The service repeatedly attempt...

I'm trying to disable the DHCP server on a UC540 running Software Pack 8.0.2 and CCA 2.2(4).I'm trying to delete the data scope under Configuration->DHCP Server in CCA per the instructions in this document: https://www.myciscocommunity.com/docs/DOC-5...

If a device is plugged into a FXS port, could it be setup where you do not need to dial an access code just for that port?  The device would never be calling an internal extension so there is no concern about overlap.

Voicemail messages are being forwarded to Exchange email accounts.  They would like their voicemail on the UC500 automatically deleted after 3 days.  They never want to check their actual voicemail on the Cisco.I set message expiry time to 3 days in ...

I have approximately 10 UC520 systems all experiencing an intermittent call park problem. I am curious if anyone else in the community has experienced a similar problem.Call park is configured and works without issue 99% of the time, however, there a...