Hi,I just recieved the Items for a UC520 Project which consist's of three sites and now I'll start the configuration, so in order to make this threat helpful for every body I'll post all the steps and problems that I'm going to face during the instal...
Just got my self a nice shiny new 9971. When will this be supported on the UC520 Series?
Hi,A customer who has a complete setup of Snom SIP phones and some sort of hosted telephony service now want's to switch to an UC500 solution. Is there a way to reuse the current Snom phones with a UC500? If it's possible what sorts of drawback would...
Hi all,I have a small PBX in my office with some SPA921 & SPA942. I have the following problem.Whenever I place a call through my ISDN line I cannot hear the far-end ring back tone. However when I use x-lite or my iPhone's SIP software everything run...
Hey Everyone,I have SNR and some call-forwarding configured and I've been having the issue that when the call is forwarded or taken with SNR that the caller-id shows up with the main line of our company and not the inital caller. I've tracked this d...
Hi,do you have to configure something special in CCA so that one of my spa525G phone's, currently connected in HQ, can be used as remote worker's phone?Are all the spa525G phones enabled by default for remote working when running the Phone VPN Setup ...
Asterisk 1.4.25FreePBX 2.6.0.22x SPA962 + SPA932 Combo5x SPA942Please assist...Recently users one of my sites came in one day to find that both of their SPA932 attendant consoles were showing orange lamps instead of the usual green for their user ext...
I've read some posts asking, read a few on this issue on Call Manager, but I need to know if there is a way to have a UC500 system ( UC520, 540, and 560) pass the caller id info of the calling party through on a call forward? Right now it passes the...
For a client, we have a 540 that was purchased with 8 extra user licenses, which should give us a total of 16 user licenses on the box. When we do show version we get:UC540#show versionCisco IOS Software, UC500 Software (UC500-ADVIPSERVICESK9-M), V...
Guys I am not getting the warm fuzzies from the new uc540 support group. I really have had a terrible experience with the CCA and the UC540 support staff. It really seems that the CCA is still not ready to completely configure the UC500 products. ...
We are installing an UC540 at a client here in Denmark, and we are unable to get the ISDN BRI lines to make outgoing calls.According to the CCA everything should be OK.Can anyone help with a correct ISDN BRI setup for Denmark?Best regardsPaal Hanson
Hello,A client in Greece uses tellas as PSTN provider.Tellas doesn't use the usual cp tone GR, as far as I understand, because ip-phones ring for about 60s after call is not answered and hang up by the call-in party.Any help to configure FXO ports to...
If the ASA5505 sits in front and manages the data vlan and the UC manages the voice do I need to just manually set the settings in network VPN for the firewall. I'm clueless and can't find much documentation on how it works.I believe option 150 will ...
Whenever I try to access the AA provisioning page from CCA 2.2.1, it hangs after 60%. Anyone ever experience this?
Does anyone have this working? I have my SPA500S console attached to my SPA509G phone. The UC520 sees the phone perfectly but does not see the extra buttons on the console.Any thoughts on where to begin?Ryan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: