VPN

I am trying to configure load balancing on two 3020 concentrators. When I configured it, I keep getting the following messagesLBSSF received GRAT-ARP from duplicate master[0003a08ab42b]6167 12/04/2007 16:15:15.240 SEV=3 LBSSF/85 RPT=527 LBSSF detecte...

Hi netpros,I have a couple of questions about this and hope you might be able to assist me.1.- Are VPN load balancing and failover (Active/Active) mutually exclusive ..? I mean they can't be used at the same time correct ..?2.- How does the ASA ha...

Hi, I try to restrict access to the remote site from a vpn user using a vpn client software. - concentrator vpn 3015 release 4.7.2.N-K9- vpn client release 5.0.01.0600the vpn connection is OK I would like for example, to block http traffic on the re...

We have taken over a network where there was little to no documentation. I have a remote access VPN terminated on a Pix 501 that is having a connectivity issue. I can connect using Cisco VPN Client. There is a server on the inside network that i...

Hi, We try to implement SSL-VPN with a Cisco 3845. When i log into OWA i receive a "Toolbar". Unfortunately this toolbar overlaps by default the "option" choice. It is possible to disable this toolbar?

I setup a Cisco ASA 5510 SSL VPN with the folowing;IOS 7.2SSL VPN CLient sslclient-win-1.1.1.164.pkgOut of 400 users, there is one user having problem installing the SSL Client to his laptop. The user laptop information is;IBM Thinkpad T40Windows XP ...

Hi, I have implemented RSA secure ID with our remote access setup and I cannot get the VPN client to prompt for next tokencode. It always prompts for username/password so the user doesnt know they are in next token mode. We are using vpn client 4.8/p...

hi I have 4 Easy VPN sites which are terminating on ASA fire wall and we need access from all VPN sites to each other currently all are Easy VPN sites is it possible in Easy VPN ?/

Hi, I have an access-list with the following line... permit ip host 65.119.114.3 62.140.152.0 0.0.0.31and its crypto ipsec sa shows up as this, with no packets encaps or decaps. protected vrf: local ident (addr/mask/prot/port): (65.119.114.3/...

I recently setup a VPN IPsec tunnel between two PIX devices. I ran into a problem with the remote PIX device when trying to route anything for a 10.x.x.x across the VPN tunnel. Here is the sample config that I was using. interface Ethernet0 speed 1...

Please help. Here is what I know.1. When I VPN in using Cisco VPN Client 4.8, I am able to connect…meaning the lock is closed and it tells me I am connected to my work network.2. However, when I go to click on a network drives, it says that is not ...

Hi all,I am wondering if someone may be able to point out where I'm going wrong.I want to be able to see/user the boot cycle/ROMMON mode of a 2811 router, remotely.As I understand it, the only way to achieve this is with an analogue modem connected t...

Hi,I'm setting up IPsec remote VPN access and I'm following the below guide.http://www.cisco.com/en/US/docs/security/asa/asa80/getting_started/asa5505/quick/guide/rem_acc.htmlThe only difference is that instead of ticking Cisco VPN client, I select t...