VPN

Hi,Is it possible to limit a VPN client's connectivity via a remote access IPSec tunnel? For example I have host A connecting to my network via an IPSec VPN on a PIX firewall. I only want this host to connect to host B and not any other hosts on m...

Hi, could someone assist me in the correct upgrade procedure for a pair of PIX 535s in a failover scenario, without powering them down. The upgrade would be from 6.2 to 6.3.Many thanks in anticipation.Charles

Hi all,I've got this problem with most of my users using DSL connection. All work fine using dial-up. I'm using Cisco Router 1720 connected to Pix515. Client is using VPN Client 3.61.These clients need to access Exchange mailbox via thru VPN. During ...

I have been wading through posts about connecting remote clients using Cisco's VPN software to the PIX. I have set up VPN access to my PIX 501 unit however, I am unable to reach any of the servers on my internal LAN.I have read that you nned to do th...

Hi,Can someone please confirm this for me? Based on the following paragraph from "Cisco Security Appliance Command LineConfiguration Guide", you cannot use the appliance for VPN connectivity if you setup virtual contexts. It seems to be a big limitat...

Dear all,I have a little problem with callback via PSTN line. Everything works fine, first the call, than the callback. Only after 120 seconds, the session resets by the router. ( 2610 with ISDN2 and seperate 2 line modem card)Anybody an idea ?The co...

I have some cisco equipment, i.e. 3 2501's 1 2502,1 2612,1 2924 switch,1 2521,1 2503 1 2511,.I'm setting this up for a lab.What i want to know is how can i configure this so that i may be able to remotely access my lab,so that i may do configs,studyi...

Hi All,using pix model 515Epix ver 7.01ASDM ver 5.01under configuration> device administration> Secure shell ip address allowed from outsidegetting this error: SSH Session from myplace on interface outside for user"" disconnected by SSH server, reaso...

We have configured PPTP-VPN in two routers Cisco. Here you have our configuration:.!vpdn enable!vpdn-group Group_VPDN accept-dialin protocol pptp virtual-template 1!interface Virtual-Template 1 ip unnumbered ser0/0.100 peer default ip address poo...

I've been battling an intermittent LAN-to-LAN VPN problem between two PIX-525's. A financial system at one location uses TCP/5000 for communications. Traffic usually flows from the remote network over the VPN tunnel to the financial system just fine....

We have a VPN Concentrator 3000 running NAT with about 120 users. Clients are calling that they cannot connect. After viewing the logs I see:Automatic NAT Detection Status: Remote end is NOT behind a NAT device This end is NOT behind a NAT de...

please, IS somebody know some manufacturer who can provide a wireless between bts (base station) and an unit (not mobile phone) ?I'm very interest.Please i 'm waiting for your reply .It is very emergency.Best regards.

I have what appears to be a strange IP address in the output from the show crypto sa command. It appears to give the remote peer an IP address which has no bearing on the real ip address on the far end or anything I have configured. So I guess my que...

Hi, I have been lucky enough to get my hands on 3 of these devices to install. Great machines !!!!I am having a difference of opionion with the collegue who has designed the solution. He has designed it with 3 Virtual Contexts all using shared interf...