Wireless - Small Business

I have my LAN/WAN on one floor and WLAN Devices on two additional floors which cannot be connected physically (via Ethernet cable) to the LAN. The WAP4410N is connected via Ethernet cable to a device (2nd Floor) and should connect to the WLAN of my F...

Hi, I forgot the name of the wifi cluster that I set up .... I know it's stupid ...And I have to add two Cisco WAP 321, I have 4 that works. I can access the web interface. Can I somehow retrieve the name of the cluster from the interface of this on...

After much investigation I finally found what I thought was the firmware upgrade for my WAP4400N access point, I downloaded the file which is a .img file which seems a bit off I think.  Anyway when I go to the admin page it decides its an unknown fil...

Im having issues with RADIUS MAC filtering in WAP321. I have a network SSID with WPA2-Personal and MAC filtering set to RADIUS.There are two cases of the error: With 'Filter' setting in MAC Filtering page set to 'Allow only stations in list', If I tr...

After update firmware to 15.3.3-JD3, i can not access access point from web gui. Anyone can help please... Thank you.

Hi all, I have an issue since yesterday, I have four cisco WAP 371 in my company. The last week everything was good but since yesterday I've noticed that I cannot connect to the hotspot's management interface. Actually the wifi is up and the hotspot...

Hello, I ran into an unexpected (and rather silly) problem: after factory resetting a Cisco WAP321 wireless access point, I tried to log in using the default username and password: "cisco" (for both), to no avail. I can see the web interface page all...

Dear Sir, WAP 121 Local area connection shows unplugged while connecting to pc or in switch Please help!!

I added a 3rd WAP371 to my existing 2 WAP371 cluster last night and I am running into an issue I haven't seen before.  When the device initially boots from default configuration, it grabs an IP via DHCP as expected and loads.  Once loaded, I am able ...

After about 9 months of use, my WAP371 just failed - the power indicator is red, which indicates that it cannot boot either firmware image. Note that the WAP was in normal use at the time of failure and the last firmware update was several months ag...

Hello!I am going to setup some accesspoints for a client. Currently they have two AP541N running in a cluster. I want to add a WAP571E and a WAP371. From what I've read they can't join the same cluster which means I have to use the WDS Bridge functio...

Hi, I have a problem with my WAP371 6 AP cluster. Most clients are perfectly allowed to the network and assignet IP's. But some clients (even iPhones) are refused and not allowed to the network. Any known solutions or things I can check? All AP's a...

I have setup email alerting from a WAP150 and have found a problem! There are 3 To: fields on the web form that is used to configure the email alerts, when the email is sent using SMTP relay the message gets rejected due to bad header. Upon investiga...