Hello Experts,I am new to wireless world and one of the customer has asked for a BOM for Wireless AP and Antenna.This is a production site and there are some areas where we need to consider Outdoor AP.For indoor AP I have shortlisted C9117AXI-E (Site...
Forum Posts
Resolved! WIFI planning
I've worked with the AiroNet 1830's and 50's for a little while now, but they've all been on a single LAN, I would like to use the same AP's to offer both public and private access. I assume I'd need a layer 3 switch to do this? If so, how complic...
Hello, recently I moved from DAS planing (indoor cellular) to wifi planning and I have a question for Access point user capacity, you see the datasheet says it can handle 250 devices however I talked to many designers and they said most AP can handle...
Hi, I have this error with cisco 2504: Loading primary image (Image not found) ** Unable to read "linux.pri.img" from ide 0:2 **** Launch failure ** Loading backup image (Image not found) ** Unable to read "linux.bak.img" from ide 0:2 **** Launch fai...
I read in data sheet that 9100 AP's are going to be compatible with Mobility Express in future releases.I read in Mobility Express Release Notes 8.9.111.0 that Cisco Catalyst 9100 are compatible as subordinate AP's with Mobility Express. What does it...
Recently purchased several 3702i LightWeight APs. These shipped with Software version 15.3(3)JD Our 5508 WLC is only running Software Version 8.0.140.0 , which is not compatible with the Software on the new APs. Unfortunately, The WLC cannot be upgra...
Resolved! Configuration not sync properly
Hi Team,Im noticing there is configuration not sync properly. Please do find the screenshot for issueMeraki DashboardShowed SSIDs in laptop
Hi Guys, Our customer has a WLC 5508 running 8.5.151.0 fw version. There are many local management users on the controller, most of them has only ro access. However now our customer would like to have rw access to WLC. Is it possible WLC logs all com...
Even though I tested in the lab and looks like it works. I would like feedback about this combined configuration on the same WLC from the experts in the forum. thanks
Hi Seniors, I need your help please.I just bought and updated an aironet 2802i cisco mobility express to firmware 8.10. While trying to join another AP to the controller,i got the below error message. Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) i...
When i try to connect an AP on a specific VLAN the AP is constantly blinking green, and i get this error message from the AP using an console cable "Could not discover WLC. Either IP address is not assigned or assigned IP is wrong. Renewing DHCP IP."...
Hello, I have a WLC and an Access Point directly attached to it. The WLC has MGT IP: 10.50.0.12The AP gets the IP: 10.50.0.119 (I made a DHCP Scope from 10.50.0.100-200) What do i need to do, that the end devices, which connect to the Accesspoint, g...
Resolved! PoE+ Distance
Hi All, I have cisco 1562e with this type of antena: 2x AIR-ANT2568VG-NThis AP will be powered by C9200L-24P-4G-EI will use cat6 cables. If I understand correctly, this AP with antennas require 25w, so C9200 provide PoE+, so it should be enough, am ...
hello, I have a 702i access point that will join my 2504 controller (ver 7.6.130.0) ok, I can see it listed and getting an ip, but it's operational status remains down. I've enabled admin state, reset, cleared the config, and the ap operation status...
Android devices files to resolve local server host name over the network
