Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi Champs, We are going to setup point to point bridge between 2 sites. Since 1532E has 2 interfaces, could someone please advise when do we use LAN interface and when to use WAN interface? Site A will have connectivity to the controller. We need...
Hello , I have 2 WLC 3504 and need to connect the Redundancy ports -> I checked the deployment guide and found that they should connect back to back or via L2 switch , the question can I use L3 switch instead of L2 switch ? thanks
HelloI am looking for a support matrix for following WAP/WLC combos. Is there any document i can use to make a support matrix like this? We are planning to upgrade to the C9800-80 and need to know which WAPs i can reuse and which i have to replace. I...
Hi We are using Meraki MR33 access points. I am unable to ping from one client to another. Whats the issue? Is it ap problem to some setting on the meraki?
Hi I setup AP with static ip address(10.0.0.120/28). After AP is connected to network and joined wlc, I notice the ip address changed to 10.0.0.115. Why that happened? Thank you
I have a customer that wants to use a 1532I bridge to connect two buildings. The buildings are about 700 feet apart with a clear LoS between the two points. Would the 1532I reach this distance?
Hello Experts, I have a client that currently have 2 5520's with several older access points 3500/3700's. We are going to be replacing them with 3800 series/1562's access points.We understand that we cannot upgrade the WLC at once because we would lo...
Hi All, i have a scenario where the WAP 3800 is not joining the WLC available locally within the building but goes and joins the WLC available over the WAN link on HQ Office. when i check the LAP i see it sending the discover request and gets the re...
I have some Mobility Express deployments that are managed through Prime Infrastructure. Occasionally I am getting alarms such as the following logged in PI:Maximum client limit '20' reached on interface '802.11a/b/g/n/ac' of AP 'wrcsap25'. Maximum cl...
Presently my APs are set to a Default profile and the Users tend to stay with an AP rather than swap to a closer one. In reading the Meraki documentation is had multiple RF Profiles besides the Default. I'm wondering if switching to an "Open Office" ...
I am receiving an increasing number of "This page can’t be displayed" messages when trying to access my system..While the ping latency is <1ms I still suspect packet loss and timeouts..The issue is observed with all browsers.. (win7p) but strangely ...
I'm looking to upgrade our Prime 3.4 running on a Gen 2 appliance next week. I normally like to upgrade when an MR is also out. Does anyone know if 3.6 will have an MR soon or early impressions on its stability compared to 3.5? We manage wired and...
Hi All;I have Cisco 3650 (SW Version: 16.3.8) and it working as Wireless controller,All four access points I have (AIR-AP3802I-B-K9) joined this controller and clients are connected to the WiFi.Unfortunately, there 2 syslogs always popping : *Jun 20 ...
Is there a way within Prime to achieve the following - Create a scheduled task to move APs from one AP Group to another at various times of the day?
Hi every one,everything working normally , and APs connected with WLC normally ,now WLC stop working and the light of ( SYS & ALM ) light up orange , then i reset the WLC and connected console and this logging appear : Verifying boot loader integr...
