Wireless

Hi Everyone, I have set up new WLC-5520 and testing AP 3700 series to join. Currently no AP is joining the WLC as WLC and AP are in the same subnet. But I can see on WLC this re-occurring message on the terminal Same gateway prevails *osapiBsnTimer...

I had 8.3.111 showing on one the 3802Is in a subnet.  Updated using the zipped files from the 8-3-112.zip file. I rebooted everything and on the software management page it still shows 8.3.111?   Not sure what is wrong. Is there another piece to upda...

I am planning to install 20 - 30 IW3702 access points.  Reading through the installation guide it refers to shielded cable. My plan was to use CAT6A unshielded Twisted Pair (UTP) feeding from my network switch out to the APs.  Is this an issue, will ...

Need assistance how to configure 1815w AP for POC at customer site , where i got info that i can configure mobility express and test the coverage for a customer . But i dont see an RJ45 Console port and in data sheet and software download i saw only ...

I'm trying to add a new dynamic interface, that I will tie a specific WLAN to so that clients on that WLAN is in the correct vlan. After adding it I loose connectivity both to the main management address (10.99.0.60) and to the ip address of the dyna...

Hello, Could someone help with our performance? I have a configuration: 2x 3650-48TQ in stack with core IOS-XE 3.5.7E configured as Mobility Controller 10x AP1832i directly connected to switch 1 through AIR-PWRINJ5 ( according Data sheets this power ...

Refer the attached snapshot.

Hello all! I am testing 8.3.112 and I am finding that clients are not reliably getting IPv6 addresses. On 8.2.130 clients reliably (as in always) get an IPv6 address (using SLAAC) and see the RAs from the router, however on 8.3.112 I am finding that ...

Hi All,  I have a customer with over 150 access points that needs to be setup in flex-connect mode. Usually I choose a separate subnet for APs and SSIDs of /23 or .24, here they have some limitations with vlan/IP subnets available for use.  So I am ...