Wireless

Hi Anchor WLC 5508 - 8.5.134.0 Foreign WLC 8500 - 8.0.152.0    I'm not new to this, been creating Mobility Anchors for years, but I've not seen this issue before, specially when was working.   I've got 1 Anchor on DMZ behind a Palo Alto FW. 3 Foreign...

I have set up site maps inside Prime 3.2.  However, I am not getting any color representation on the maps.  The APs have been in the proper locations on the floor maps.  Am I missing a step or a setting?

what does [None WPAv2 PSK] error message mean?   parent lost: received disassociate (1) failure associated to AP_MAC and then [None WPAv2 PSK]   it repeats and repeats.   What could be the issue here?

I have configured 1602 as bridge and other APs are at local right now. I have to change AP from local mode to bridge in order bridge AP to work, correct?   Below is the show logg from the AP   8 00:58:17.031: %DOT11-4-CANT_ASSOC: Interface Dot11Radio...

I wanted to reach out to the community and ask if anyone has run into any bugs or issues when upgrading Cisco ISE 2.2 to Cisco 2.3 or 2.4?  This is specifically with wireless since the environment i'm working in is currently running 2.2.  Any land mi...

Hi ,    I am setting up a new vWLC in VMware. 1. why data port should be trunk? what it is used for ? 2. I already have a vwlc in production how to find the data port ( ip address ) of that vWlc ? 3. Difference between management port , service port ...

Our end client has configured an external syslog server(SIEM) in the Cisco prime infrastructure.And for testing purpose, he has tried login in to the Cisco prime with wrong credentials. In the syslog server, although he is getting logs for bad authen...

HiI have a cisco wireless AP AIR-LAP1242G-E-K9When I plug the network cable into the back this lights come on and change colour.Does anyone know what the lights mean when they change colour?ThanksRegards

Hi,   I am trying to integrate my Cisco Prime with ACS. but its not successful. I just followed steps from the below cisco document.- "Use Cisco ACS With RADIUS or TACACS+ for External Authentication" https://www.cisco.com/c/en/us/td/docs/net_mgmt/pr...

Im trying to restrict or block others SSID from other controllers with my WC 2504, it is possible to do that? To make our clients not to see others SSID that are not configured on my WC?

WLC software version: 8.1.102.0 I want to use the LetsEncrypt Wildcard on WLC Web Authentication CertificateBut when I upload thie file, it always says that "File Transfer Failed. Seeing the message logs, it pop out that*TransferTask: Feb 20 04:10:30...

I have a Cisco 3502I Access Point that shows as registered in Prime Infrastructure but it is not accepting clients.  I have already deleted it,   added it back,  and it has been rediscovered by the WLC but it still does not accept clients.....  Can s...

Hey all,   After upgrading my WLC 2504 to 8.4.100 i no longer had the 25 licenses that the device shipped with from the factory..   Any idea what happened or what i can do to get them back.  Been running on the temp licenses for a few months until i ...

Hi,  Currently, I have 10 APs and would like to add extra 5, problem is I get no reply from tftp server error.I've already enabled the port on inbound and outbound on the firewall, still no luck. Any help would be appreciated.