Wireless

I have a few 5508 wireless controllers and the hardware is getting old.  I have to decide if I want to purchase additional licenses for the existing WLCs or purchase newer hardware.  Purchasing just the licenses is a cost effective solution right now...

Hey Team! So we have a problem about AIR-cAP1702I-E-K9 need your support: 1- Following datasheet AIR-CAP1702I-E-K9 ( http://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1700-series/datasheet-c78-732347.html) we see transmit power of AP ...

We have a WLC running 8.2.121.0 that has Wireless 802.11b > RRM > Tx Power Control(TPC)) > Minimum Power Level Assignment set to 10 dBm. On a 2802 AP, that should be about power level 5. The WLC Power Level Assignment Method is automatic. The APs are...

     I have a 3703e AP that has failed and is displaying a "white" light from the LED.  I can't find that error light in the documentation.

Hi Can you help to know if this " the overall 2504 WLC throughput stays 1 Gbps no matter how many ports you connect" remain in release 8.0 and leter software on this model. Thanks for all you help.

Hello! We are facing a very annoying problem at the moment in our company. Our Wireless infra is based on FlexConnect with locally switched WLANs and central authentication via ISE1.2. Our corporate machines are based on Windows 7 x64, native supplic...

We've just finished deploying a large number of 2802s to several remote sites with a centralized controller (5520). We also have a Prime Infrastructure server set up. Are there any tools to look at to help with troubleshooting. I'm specifically think...

We have just installed a prime 3 UCS we have been using prime 2 in a virtual environment. One thing we can't figure out is how to set the second NIC of the UCS to work as part of an port channel group. we want this to allow for resilience if we have ...

Hi, Currently I do some research on WLAN management frame, as I collect the frame, I observed that one of my cisco AP only transmitting the neighbour messages to the other AP but there is no other management frame coming out from that AP. Is there an...

Hi All, I have configured a master controller with a new firmware installed  AIR-AP1830-K9-8-3-112-0.tar to be a ME The Management IP i provided is 192.168.108.99 - This is off the network. For me to setup the secondary AP, I have a few questions:1/ ...

I have an RF profile to limit the number of 5Ghz channels applied to a group of 3802s.  The 3802's that are running with a 2.4 and a 5 radio correctly use the channels in the RF profile.  The 3802's in FRA mode with dual 5 radios do not use the chann...

I purchased cisco 2504 controller with 5 ap licenses. but I have 6 APs. That's why I also purchased 1 ap adder license. As far as I know this adder license is built-in in 2504 controller. but I can not use it. when I connect to ap's then 5 ap is bein...