Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hello, I have a converged access architecture with 5508 like MC and 3850 like MA. Currently in the main site, the access point are registered on each 3850. For my remote site, i don't have cisco 3850, and i want to use FlexConnect towards my 5508. So...
Hello team, Can i join Aironert 700 series access pointas clients to Mobility express 1850 as controller.?? Then what shoild be the Criteria and compactibility?? Anybody have views on it??
Hi everyone! I have an issiue with my WLC, when I configure the interfaces and te AP´S for the firt time the will work well, but the problem is when I reset the WLC I can´t see the Access Point Anymore. Only if I reset the WLC I can see them again. C...
Hi all, What is the best way to debug clients which are disconnecting after about 5 minutes ? I've got Management > Logs > Config > Msg Log Configuration to Debugging, but this doesn't seem to show clients connecting or disconnecting, and more impor...
Hello, I have a CMX 10.2 located in a DMZ for External splash screen for guest authentication at a remote location using a Cisco 5508 WLC. after we setup the CMX, the guest can authenticate just fine!!! but now any body can access the web based manag...
Will access points installed at a branch site (different subnet) automatically find our WLC 2504 at our headquarters over the WAN? The sites are connected via MPLS. Does CAPWAP automatically jump from one subnet to another over a routed network?
I'm looking at some Cisco WLC configs for a customer and under 2.4GHz settings, 11mb is Mandatory, and 5.5, 6, and 9 are set as Supported. 1 and 2 mbps are disabled. There is no other Mandatory rate set on the band. Can anyone give me an example of...
I have a 5508 series WLC running 8.0.135.0. I have noticed that the rogue APs do not show up in the GUI until you run #show rogue ap sum in the CLI. Then again to get an update you must run the CLI command. Has anyone noticed this?
Hi all just small Question about MSE version 10 if i buy it as a virtual can i installed in hyper V or not ? and what is the specification for that ? thanks
I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?
I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?
I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?
I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?
I HAVE 4 AIR-AP1825E-N-K9 and a wireless Controller 2504 but I can´t see them on the WLC? IS PROBLEM WITH THE FIRMWARE OF THE WLC?
Hi On a WLAN network for one of our customers we only allow APs to connect if they authorise against a AAA radius server using the mac address of the AP ethernet interface as the username and password. Currently we do this using an ACS as the AAA rad...
