Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hello,I need to stage an AP as client, 801.x supplicant.The WLAN use PEAP/MSCHAPv2 authentification, do you know if it is possible to do it ?The purpose (which is mandatory) is to connect the AP (as bridge) to a switch where 4 PCs (non WLAN) are wire...

Hello.My WLC 2504 failed to boot. The SYS and ALM leds are solid amber. I think my bootloader i broken. I have no service contract. Is there a way to get my hands on the bootloader software such that I can reinstall it myself? Thomas

thl by Community Member
  • 2032 Views
  • 6 replies
  • 0 Helpful votes

Hi Just running some tests on the 8500 running 7.6.120.0, one of the test was to simulate the HA box failing, by removing the layer 2 connection and shutting down the interface.The test  bed APs were on the primary box and with test clients active, r...

Hi, I am trying to create a mac filtering template in WCS. I am trying to import from a csv file. I am getting below error "Invalid MAC Address '"00:24:d6:68:7c:16' at line 1". But my template information seems to be correct. I am attaching the templ...

Hi,Is it possible to send config-change alert with details from WLC 4404 to syslog or snmp server?Under SNMP parameter, config-save option is enabled but it is only showing config saved snmp message which is not sufficient for us.Regards,

nomair_83 by Spotlight
  • 3348 Views
  • 6 replies
  • 0 Helpful votes

Hi.I have two WLC 5508 in HA, configured with WLAN for local switching and flexconnect APs.i'm running code 7.4.121.0i'm using ISE for authentication and NAC policies.under the WLAN, radius NAC is configured and sometimes authenticated clients obtain...

moti haim by Frequent Visitor
  • 1472 Views
  • 3 replies
  • 0 Helpful votes

I hope I am in the correct forum for this topic?For some reason I cannot access the web interface in order to configure this device. I have it connected to a router (DHCP). The router assigns an IP Address and I can ping it. If I attempt to go to tha...

mistertokr by Community Member
  • 1430 Views
  • 4 replies
  • 0 Helpful votes

Hi, when i plug my AP to the network the Radio Led stars blinking in green. After a couple seconds the Ethernet led becomes solid amber and the radio led shuts down. The outside status light is also amber. This is what i see on the console when the A...

Review Cisco Networking for a $25 gift card