Wireless

Hi.I have few APs working in hreap mode as local switching. I have Guest WLAN and after connection to that WLAN client must accept security regulations. The problem is that on WLC under Security->Web Auth -> Web login page  I put text saying:"Read a ...

Hey, everyone!. I was pondering on getting a certificate fro ma public CA to maintain easier configuration for end users.There will be a multitude of devices on this wireless network configured with 802.1x PEAP. (iPhones, iPADs, Droids, and PC'sof co...

Hi,Can someone please clarify the maximum throughput of a 2600 AP when using CLient Link 2.0.  I see that the datasheet states that it is 450mbps, however,  from my understanding of transmit beamforming (client link 2.0), when traffic is "beamformed"...

Hi,     I am looking for an AP with two ethernet ports. Is there any model of Cisco is available with 2 ethernet ports?Regards,Noman

I have a Cisco 4404 wireless lan controller managing about 85 AP's.The wireless side is setup for a private wlan and a public wlan.  On the public side, users are directed to a captive-portal agreement page before they can get on the internet.  My qu...

Folks,         I have 4 ports of a 5508 connected to 4 different switches. The 4 switches are in different Pods. I want students in these pods to be able to access the management IP of the 5508. Any ideas?                  

Does anyone know a set of CLI commands that I can use to determine the IP address for the Non-Root bridge (Cisco 1310 running 12.4(25d)JA1) that a given MAC address is behind. For this case, the root-bridge is trunking VLANs across to several non-roo...

Good afternoon,I need help with erasing the above unit i have a cisco rolled cable attached to the back of the laptop in the serial port, but i also have a serial Console port on the wireless lan controller as well how do i go about configuring the u...

Hello, we have a 4402 controller with sw 7.0.116 and a wcs with sw 7.0.172.We have to create a new wireless network, and would like to send the ssid to only one AP. Is this possible ?regardsJohann Folkestad                  

HiI work in a school with a managed wireless system. Managed by the Cisco 2500 controller.My issue is that when the children and teachers log on using a Mac they can not see any of the Windows servers. Most of the work is saved on shares on the Windo...

HiI work in schools and we have a couple of schools that use a cisco managed system. The guys who installed it suggested that we can use the AP's or box to push out proxy settings. They didnt however tel me how and are very good at communicating.Does...

Hi allI would like to ask about vlan configuration on access point Airone1242.Is mandatory connect it into trunk port on the switch ? , i will use only one Vlan through one SSID exept of native vlan. I m going to connect it into access port on switch...

                   Hi All,I’m having a problem of joining new Aps( Ari-ap1242G-E-k9 ) to the following wireless LAN controller. WLC details as follows, Model No - AIR-CT5508-K9Software Version - 7.0.116.0 AP Model - ARI-AP1242G-E-K9 AP console logs a...