Wireless

On a WLC 2504, Is the the local radius database the same as PAC (Protected Access Credential) ?

Has anyone tried to use VLAN for HA-SSO RP connection on 5508? Is it possible as VLAN can be used for WiSM−2 WLCs?The deployment guide says: "5500/7500/8500 WLCs have a dedicated Redundancy Port which should be connected back to back inorder to synch...

Hi allWe are trying to configure a C5760 for webauth, but cannot find the place to set the hostname for the Virtual IP address ?As far as we can see there is no mention of this in the configuration guide as well.What should we do ?/Thomas

Hi All, I have worked on WLCs and 1262n lwaps but this is for the first time I am working on WAP121, we forgot the username and password for this box, I just want to check how we can recover the credentials of this WAP.Any help is much appreciated.Th...

Hi,i have 1260 AP (Autonomous) and i want the clients to connect only at 5GHz MCS rates (802.11n) and i dont want clients connecting at 802.11a data rates. i tried to do this from AP GUI but it says i have to enable at least one data rate from 11a. P...

Will the cisco 1230 access point work in lighweight mode if it is using a radio?

Hi Guys,I will need to configure IOS (standalone) 2602E as access point as wireless bridge. When I try to disable 3 out of 4 antenna ports (only enable A) for wireless birding it won’t save I get white screen but if make changes on rest the setting I...

hi, I´ve connected two 1042 Access Points and when they start they say: No Mesh startup file foundand it lasts very long until they connect to each other what´s my problem with this error messageI´m using two 5508 controller in HA mode with AIR-CT550...

Here is the setup. We have a series of 3560 switches acting as layer 3 devices. The campus is subnetted based on location and application. For instance, one building would be say, 10.13.x.x. The interfaces on the switches are configured for either da...

I have a 5508 WLC. Where do I increase the session time for a WLAN session? We have a BYOD segment and have been getting complaints that users are being disconnected after about 45 minutes.                  

I cannot download/update any apps while I'm on Wifi. turning it off and using 3g works fine.---Posted by WebUser Siddhesh Bhosale from Cisco Support Community App

I'm trying to use the cli to configure interface groups on the 5706.I'm looking for examples on how to do this and how to map those groups to a wlan.It seems that vlan groups are the same as interface groups on the 5706.i.e.1.         vlan group grou...

I have a 1040 AP on my network but I am having several issues with it but I think most of it is my lack of experience with Cisco products.  Hopefully I can get some questions I have about the AP answered here so I can help stabilize my wireless netwo...