Wireless

Hi Team,During centralized WLC 7500 controller connectivity with branch office AP , can we use the public IP address in WLC management , in case we are not having VPN connectivity between Remote to branch location & only had a internet in both end . ...

Hi,I have a Cisco Access Point 1140 Series, and the users has problem when they try connect to the Wireless.In the console I have these messages:%DOT11-6-DISASSOC: Interface Dot11Radio0, Deauthenticating Station MAC Reason: Previous authentication no...

Hi all,we have a lot of problem in joining AP 1600e lightw to a vWLC.Following the details:- vWLC: 7.4.100 (with SSC disabled)- AP: ap1g2-rcvk9w8-tar.152-2.JBWe followed these steps:- AP directly to vWLC: results: DTLS Error     "*spamApTask3: Jul 18...

Hi AllIn order to have remote AP connect to centralized WLC do we need specific model of AP on remote site.remote site is connected to central site with incountry MPLS To get good handson WLC which is the recommended cisco course to attendthanksST

Having issues with setting up LAG on a Cisco 2504 WLC and implementing VLAN tagging on the different SSID´s.Without LAG I had this up and running by using dynamic interfaces and assigning the different SSID´s to a perticular interface which was then ...

Hello.Whet I connect to %subj console with putty I see only blank screen but when I send break - I see 2-3 lines on device output. Like this:---------------------------------------------------------############################╨Йnщ;vwwьre, C1130 Softw...

Dear All,I have a WLC 5508 and a brief connected like below.Internet->Router->2960G A-> (Port0)  WLC5508 (Port1) -> 2960G B-> Access Points <-> wireless clientsMy Question : Is the above topology work? The access points register to the controller via...

Hi guys,I found this information at http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_hotspot_msap.pdfGuidelines and LimitationMobile Concierge is not supported on FlexConnect access points.It's for 7.2. Does anyone knows...

Please refer to my pic below:  example, i do have one switch, with all LAN ports (1Gbps) and my wireless ap, connected to this one of the port  Q1 Let say my wireless ap, can support up to 54mbps, and how much speed for each clients if  1. only 1 use...

I see that one needs a 50 AP license to run HA.  We have two 5508s at our datacenter running about 22 APs.  Both controllers have a 25 AP license as this was the old redundant model.  Is it not possible to get these controllers into HA because they o...

Hi All, I am going to deploy Wireless APs with Wireless LAN Controller at one of my customer office. In the first phase, what they want to use their existing single VLAN infrastructure integrated with Wireless, means they want to extand their LAN on ...