Wireless

We have WCS (7.0.172.0) and WLC 5508 (7.0.116.0) we have in our network environment and have worked well for a while. A week ago, the client counters on WCS monitor are not updated any more. Does anyone know why WCS stop displaying current client cou...

One of Cisco presales partner suggested we upgrade to Cisco Prime NCS. Currently we using WCS version 7.x. Could any one tell me what are the drawbacks of upgrading to NCS?I like the idea how NCS can manage wired as well as wireless. Any feedback is ...

/* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0cm 5...

HiOne of my coluge work in a organization . This organization has own campus where have office , Auditorium, Guest Building, Residential area and Training Center. They plan all the campus work with in Wireless Network.For that reason which keypoint i...

I have been trying to upgrade my firmware on a single WAP4410N from 2.0.2.1 to 2.0.4.2.   The upgrade loads but after the upgrade I can not make any changes to the configuration.  Nothing it saved.  I have also tried the 2.0.3.3 version with the same...

We have 1310 AP with the following IOS on the device will this work as a standalome mode as we dont have wireless controller with us.Here is the part numberS131W7K9-12307JA        Cisco 1310 Series IOS WIRELESS LANhttp://www.cisco.com/en/US/prod/coll...

I have WLC AIR-WLC4402-50-K9 have 50 AP license. The running image on WLC is 4.2.207.0. I have Access Point AIR-LAP1242AG-A-K9 having Image version 12.4(10b)JDD.AP Model......................................... AIR-LAP1242AG-A-K9IOS Version.............

I'm running a NME-16ES-1G-P in my 2811 and trying to run poe to my AIR-AP1200's and also older pre-standard phones.I have CP-7941 accepting af power so I am confident that the AC-IP power supply is functioning.I have a AIR-PWRINJ3 which supplies powe...

I am new to wireless.  I would like to statically assign ip addresses for my controller(AIR_WLC-2112) and my access point (LAP1042N).  I would then like the controller to distribute dhcp addresses for users.  What is the best way in doing this? 

Hello,is-there anything special to do prior to enter this command:sh client roam-history <mac address>I have this result:unable to get L2Roam Mobile Historyeven if I enter a previousdebug client <mac address>Thanks for your help,RegardsGerald

I have an AIR-AP1131 that I use for wireless surveys.  The case is cracked and broken.  Does anyone have a broken AP that I can get so I remove the case and use it?  It would be greatly appreciated. 

I have Cisco 1140 AP which I have configured as WPA2-AES encryption.To get maximum throughtput I shutdown 2.4 GHz interface and transmitting signal only on 5 GHz and channel width is 40 MHz.I am not broadcasting SSIDNow when I connect two windows XP ...