Wireless

We have started to deploy OEAP's and the problem of multiple employees living withing close proximity to one another.  Is there any way to apply AP-specific MAC filters in order to limit which hosts are allowed to join the remote AP as to not allow o...

Hi all,i have two wireless networks with two subnet (see the attached drawing) , all controllers run v4.2 access points type is 1020 .the first network in hall 1 have 4 wlc in subnet 172.16.40.X  , the security is WEP key for wireless phonethe second...

In the configurarion of PEAP the Certificate Services (ISS), the CA Type... Can be Standalone?http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a00807917aa.shtml#t6Step3.: On the CA Type page, choose Enterprise root CA and...

HelloThis may be a daft question but I have no real experience on Cisco WLC's and I've been dropped in it at work so bare with me.I am wanting to set up a new WLAN on the controller and give it a private address range 10.x.x.x.  Id like to NAT this o...

Hi all,I am trying to set up radius authentication for the management users of WCS. I am using freeradius.I created a user and set included the necessary group tasks in the reply using Cisco-AVPair. I can see in the debug on the radius server that th...

hiwhen i try to set SSID in my access piont with CLI.  with commandAP(config)#interface dot11Radio 0 it is a invalid command.??? i tried  several times. what's wrong here????/

Simple question - does removing the checkmark next to the "Admin Status" field disable the "A" radio completely?  I'm trying to prevent power alarms b/c we don't have sufficient POE to power up both A and B/G radios.TIA,Amir

I have a AP1220A I'm looking to configure it so that it blindly connects to any unsecure network.And then I will be able to use the CAT5 to provide my router with internet connectivity.Is this possible?

Hello everyone, I've been trying to track down a very stubborn problem that I've been having at 2sites now; the client computers show repeated syslog entries ofEvent 4201 - The system detected that the [XXX adapter name] was connected to the network,...

I have a couple of Aironet 1100 series APs that should be connecting with a Cisco WLC 4400. Started with one that was seen but not set to the correct radio setting but the WC didn't have a place to reconfigure that setting which I could see. So using...

Hi to all,I've reading a bit about this and i'm a litle confused.We have a 5508 Wlc with many 1140 aps. And i would like to know how many clients can handle each access point.On this device there's a param under  wireless-802.11a/n 802.11b/g/n - gene...

i have two network seprated by firewall one side network is with WLC and 2 AP if i want to put 3rd AP in a zone which is behind the firewall what configuration is required and how AP will join WLC.Thanks