Wireless

hello,i'm running wlc9800-40 17.6.4 version and i'v got this errorSeverityProcess NameMessageCriticaliosdApr 10 23:47:04.326: %IOSXE_QFP-2-LOAD_RECOVER: Slot: 0, QFP:0, Load 45% recovered.5 secs traffic rate on QFP: Total Input: 13034 pps (13.0 kpps)...

I have setup a SSID with use web policy using the inbuilt web auth page on the controller. I have setup flex connect profile and selected the central authentication option only. The problem is when i connect to the SSID the captive portal tries to lo...

Good morning, all!I inherited a Meraki network and am loving the simplicity. I noticed in one area of the office users were letting me know of slowness. I ran a speed test and got about 50mbs, I also ran a throughput test via Meraki and it didn't sho...

Hi,I am trying to setup a CW9162 for the first time on our network and when connecting it to 2 separate network scopes, the lights initially show that it is trying to update the firmware then will change to flashing red & green. I've checked the swit...

Hello,We have replaced our MR32 for a mix of MR42/MR52 and since this change, we can see that performance (bandwidth) slowly getting lower and lower and almost tend to less than 1 Mbps. Only a reboot of the device permit to have good performance back...

Hi Community,Is there a table on how far each of the RADIO Transmit power can reach? I read from this documentation (https://documentation.meraki.com/MR/Other_Topics/MR_Access_Point_FAQ#:~:text=However%2C%20barring%20radio%20interference%20and,a%20ra...

Hello everyone,I’m looking for some advice on managing our wireless network’s guest access. Currently, our setup grants guest access for 24 hours via a built-in captive portal. However, we have a situation where we need to extend access for a group o...

Hello,I have a Cisco c9120axi-e access point, and I want to configure it, but the SSID is not displaying. I connected it with a router, it got an IP address, but the web interface of the access point is not accessible with its IP address.Best regards...

I am having issues with my Meraki wi-fi and the radius server. The radius server will intermittently stop responding about 1-2 weeks and I have to reboot the server. It takes 2 reboots to get the authentication back. I am not having an issue with it ...

Hello, My company has a historic wifi network that is beginning to show its limits, we would like to update it. It consists of a cisco 5508 controller, and a hundred AP702, AP1602, AP2602 terminals. Would it be possible to replace the controller whil...