Hi Team,
I met a issue that the mobility tunnel can't be built between WLC3504 and WLC9800-40, their version meet the ICRM requirement, I suspect the issue happens since certificate using by DTLS, I saw the logging information as follow:
-------...
Folks, I'm having a hard time determining if the C9120AXP access point and the AIR-ANT2513P4M-NS are compatible. This is for an internal warehouse implementation. I see pages that specifically state the C9124AXP is compatible, but that's an external ...
Hi,Network Setup Overview:I have deployed a wireless network using Cisco Business Wireless CBW240AC access points and a Cisco C1000 series switch. The setup includes seven CBW240AC access points, with one configured as the Primary AP and the remainin...
Hello, I would like to block a device on just one of my SSIDs. Is this possible? I currently have 4 SSIDs on my controller, and I would like this device to not access just one.
Hi all!I just want to know is there a way to configure rate limit for authentication and association request to prevent the flood attack, either on AireOS and IOS-XE WLC.As in my understanding, this type of attack aims to AP's association table if th...
I want to install c9800 in workstation
The installed c9800 does not ping to the pc.
Workstation (c9800) - switch - pc connected,You set up svi in the same band as the same vlan.I caught the gateway in c9800 with the svi ip I set on the switch.
pings ...
The Meraki CW9176 has a built-in GPS capability, allowing it to provide location information for self-location and associated purposes. If I have a challenging environment, where none of the APs (all CW9176) can "see" the sky, how can I get location ...
Hello, everyone
I am studying Roaming for my ENCOR exam.
My question is, how exactly does roaming differ if we have an inter-controller roaming scenario where the WLCs are in the same mobility group versus a scenario where they are in different ones?...
I did it. I was too sleepy and the next day I realized I deleted both partition. One is completely empty and the other one is bricked and not bootable.
Bubt doesn’t want the tar because it’s exceeds the file size limit to write. And to nand write the...
I am trying to connect my new controller to sccm. However when I try it only resolves a ipv6 address and that is not routed through my network. 9800-cl#telnet smartreceiver.cisco.com 443Trying 2A04:E4C7:FFFE::F, 443 ...% Destination unreachable; gate...
Hello, I have set up a guest portal with Cisco ISE and 9800WLC, and it was working fine. until I found out that some clients when they select the SSID the sign-in portal does not come up. after troubleshooting, it seems like it's only happening on IO...
While attempting to work around a different issue, I realized that the XOR Slot 2 radios in Cisco 9166s provide very slow throughput when in 5GHz mode when they've been up for a time. Throughput is as low as 30Mbps up and down in an empty room with a...
I'm facing issues with no internet after I access ClearPass Self-Registration CWA. The self-registration only asks for name and email. I'm able to ping/resolve external hostnames, but unable to browse. Has anyone seen this issue on either ClearPas...
