Wireless

Hi allWe are running a project where we want to install some autonomous access points but later to convert them to LWAPP, Is it possible we can use the 1240AG access points for this or do we need another kind ?

Hi there,We have a 32-access-point network of AIR-AP1231G-E-K9's, all running off of 3750 PoE switches. They are standalone access points, the designer/installer (not me!) decided it would be cheaper than using a WLC.Anyway, I am having a few problem...

I have a small conference room that has several guests attending events throughout the month. We would like to give these guest wireless access. I would like to run where I issue the guest(s) a username/password for the day. The would boot their lapt...

Can anyone explain what the difference is between admin status and oper status within the WCS GUI. It appears that disbaling either on effectively disables the radio...is that correct?

Hi everyone, I am a rookie at computers. I have 'cisco systems 350 series pci wireless lan adapter' and it does not work because under device status it says "This device cannot start (code 10)" I've uninstalled it and re-installed, updated the driver...

I recently have added a second Vlan on my access point. However, it's not getting an ip.I am VERY new to the whole Vlan stuff and to more advanced networking so i am not sure what is wrong. I am thinking maybe it is because the AP is sitting behind a...

Hi!I have a 870-router running 12.4(9)T2.my setup consists of a bunch of PC's connected using a 3com wireless bridge and one wireless laptop. The 870 is also acting firewall, so it has an internet connection in fa4.All devices can reach the router an...

Is anyone else having problems with WISM based controllers unexpected crashing? I have an open tac case and I did get a replacement module for one switch, but I am not confident that the problem will go away. The system is not logging anything to the...

Dear,I'm in the need of temporary replacing a 2006 controller with a 4404 controller. I have all the 2006 templates in wcs. Can i expect big problems when pushing these templates to the 4404 ?

Hi, have anyone encountered during power up of Cisco Aironet 1410 (with integrated antenna), the Install LED status is solid amber all the time? At Bridge LEDsInstall LED - solid amber3 LEDS - noneAt power injectorUplink - OffInjector - Blinking Gree...

This is the scenario; Before I upgraded Windows XP to Service Pack 3, the Cisco Spectrum Expert worked fine. Once I upgraded to Service Pack 3, it doesn't work anymore. The program starts, but it is not detecting any RF signals. When I check to see i...

CISCO 4404 ALERTS TO BE GENERATED(mail has to be triggerred) WHEN WLAN CLIENT AUTHENTICATION FAILS.Is there are any options on WCS to enable Authentication Failure on WCS.I have already Enabled 1.Client authentication failure Alarm and Authentication...

Hi, a I have this question:To run the Cisco Spectrum Expert Wi-Fi is necesary a WCS running in the Wireless Network ? I have a Wireless LAN, with Autonomous Access Points and would like run Cisco Spectrum Expert Wi-Fi to monitor my WiFi Network.

Are there any known issues by installing an antivirus software or upgrading to (microsoft) service pack 2 or 3 ?