Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Is it possible to have a 1242 connect to a 1242 via the A radio for a bridge and then service clients on the B radio? The ethernet connection is setup on LWAPP. How could i go about doing this or is there some documentation someone could point me in ...

CDP is a layer 2 protocol. Therefore, I have to assume that in a layer 3 routed architecture for a WLAN controller that the CDP information is tunneled back to the controller. What would cause the controller to NOT have accurate CDP information about...

I have a number of 1242AG's installed in a factory, and one of which will not operate properly, as it is on a girder about 20m high, I cannot see which LED, but either the ethernet or radio LED is red, and the status LED is green. This occurs about h...

CDP is a layer 2 protocol. Therefore, I have to assume that in a layer 3 routed architecture for a WLAN controller that the CDP information is tunneled back to the controller. What would cause the controller to NOT have accurate CDP information about...

I consider upgrading the software on our 4400 from 5.0.148 to 5.1.151, but when I look in the help on Downloading file to the controller, it says:"The controller downloads and installs the new controller Operating System software. This process takes ...

s.hellman by • Level 4
  • 948 Views
  • 2 replies
  • 0 Helpful votes

I reciently tried to upgrade my 1231 AP to LWAPP using the Upgrade Tool 3.0 for Cisco IOS AP's. The upgrade tool stated that the upgrade was a success with no errors. Now the AP boots itself with image c1200-rcvk9w8-mx fine, then states "lwapp_crypto...

wp_morris by • Community Member
  • 2990 Views
  • 9 replies
  • 0 Helpful votes

Using a Cisco WiSM Controller w/ version 4.1.181.0 to monitor/manage Rogues and Ad Hocs.Wanting to dump the results into a database for management history -If I use SNMP to retrieve the data - which MIB do I use...Looking to get the table/results wit...

Jae_Robinson by • Community Member
  • 1243 Views
  • 2 replies
  • 0 Helpful votes

What is the trick to get the map editor to understand that a wireless signal on the 2nd floor can be used by people on the 1st and 3rd floors?

a_clawson by • Community Member
  • 815 Views
  • 2 replies
  • 0 Helpful votes

Hallo Users,i Have AIRONET Wireless Communications Cisco Aironet Wirele ss 802.11b under OS Debian Etch. This adapter install successfully, but i have no WPA-PSK. Tahnks for answer. Help me!Ralle

RalleLinux by • Community Member
  • 698 Views
  • 1 replies
  • 0 Helpful votes

A couple people i work with came up with a nice Wireless Disclaimer page that goes over a few rules with a "agree/disagree" button. My question is, does anyone know how to make this functional? I have uploaded it to the WLC, and set it where once you...

Review Cisco Networking for a $25 gift card