I am considering configuring a 1242ag as either a WGB / non-root bridge, I have read that a WGB can have only 8 clients on its ethernet lan side, and does not associate with wireless clients other then the root-bridge/AP. Can someone confirm this for...
All,I just got a Cisco Aironet 1242AG. I have it configured but it will be installed in a conference room. So there is a need to have addresses dynamically assigned. Can I configure a DHCP pool on this AP. I found some documentation but it isn't real...
Has anyone ever gotten the 871w to perform WPA with Local EAP auth.? I tried to use the Cisco doc but it was of little help.If you have this working can you please share a config.Thanks,
am Subhasis Pal working in Indian Statistical Institute, Kolkata,India as System Administrator. We have purchased two AP-1242AG model 9 months back. one is working properly. one is getting problem after loading new ios downloaded from your website. ...
I have recently upgraded two AIR-AP1220B to IOS 12.2(11)JA1. Now when looking under the Network Interfaces I now have Radio0-802.11B and a Radio1-not installed that is grayed out. Where did the Radio1 come from and how do I get rid of it? Also, when ...
Hi,The goal of our application is a data transmission network between the ground infrastructure and vehicles. On the ground, we planned to use LWAPP AP1242 managed by a WLC. On board, we planed to use a MAR3200, fitted with 2 WMIC. In a first time, w...
Hi everybody,I'm implementing an outdoor "bridge" in WiFi.I explane:I have a 5.4GHz of backbone, then a router wich finish in a RJ45 cable (all for an XDSL). I must to use a Cisco Aironet product to bring the 802.11g protocol from the technical build...
We are a fairly large campus with approximately 150 AP's. Currently we are NOT lightweight and have deployed WDS's to locations under the 'recommanded/required' standards.. However, it seems that our WDS's seem to constantly authenticate to the ACS ...
Hi folks, In a AP 1231G-A-K9 I had a problem, making an upgrade the copy did not finish, then, right now I have the next message,Error loading "flash:/c1200-k9w7-mx.123-8.JEA"Witch is my best option ?? is there some tools for that, or xmodem is my on...
Dearthis error happened when the client try to connectsome clients coneccted then disconnected the other client couldnt connect please check the attached filesplease advice wht is the main problem and how can i fix itthanks in advanc
hi am using CISCO ACS SE to authenticate my users who connect to my wireless network from the microsoft AD..am using EAP-PEAP.the authentication works fine the problem is that after authenticating and associating my Client connects for about 5 minute...
We have a wired Aironet 1130AG which we cannot connect to. We got a cable to hook it up to a computer with the Hyperterminal. But we don't know the commands to connect to it. Can anyone give us some advice?ThanksMike
helloi have WiFi network build on AIR-AP1121G-E-K9(6 AP), and CIS-WS-CE500-24LC.in this moment, its just one WiFi network with WPA2 security. q: can i build multiple WLANs on this AP?
